Photocatalytic degradation of bisphenol-A (BPA) over titanium dioxide, and determination of its by-products by HF-LPME/GC-MS

Abstract

In this work, analytical strategies were developed based on the technique of hollow fiber liquid-phase microextraction and chromatographic methods (LC-UV and GC/MS). These methods allowed the identification of the main Bisphenol-A by-products applying heterogeneous photocatalysis in water samples. BPA degradation in this study was in the order of 90%, and the conditions used in the HF-LPME were optimized through 2³ factorial design (6 cm fiber length, stirring speed of 750 rpm, and an extraction time of 30 min). Using a HF-LPME/GC-MS analytical strategy, it was possible to identify six by-products of BPA photodegradation, two of which have not been reported in the literature so far. This knowledge was quite important since the degradation can lead to the formation of more toxic and persistent by-products than the BPA. With the Toxtree software, three degradation products were found to be persistent to the environment, in addition to BPA; however, in 360 minutes of reaction, chromatographic peaks of the precursors were not identified, suggesting that there may have been a total degradation of these compounds. The results showed a great application potential of a miniaturized extraction technique to extract and pre-concentrate the degradation products of emerging contaminants.

Graphical abstract

Keywords:

• Heterogeneous photocatalysis
• HF-LPME
• bisphenol-A
• titanium dioxide
• GC/MS

Additional information

Funding

The author(s) reported there is no funding associated with the work featured in this article.