Residual stress measurement of Al/steel dissimilar friction stir weld

ABSTRACT

The dissimilar welds between aluminium (Al) alloy, A6061-T6, and stainless steel, type 304, were fabricated by a friction stir welding (FSW) technique. The FSW tool was offset to Al side and the probe was inserted only into Al plate. The softening occurred in Al side due to the heat input during FSW, while the hardness increased by the post-ageing treatment. Tensile strength of dissimilar weld also increased about 8.5% by the post-ageing. The residual stresses were measured based on the cos α method. The residual stresses parallel to the weld line, σ_xr, were predominantly tensile, while those perpendicular to the weld line, σ_yr, were compressive. Post-ageing treatment had little effect on the residual stresses.

KEYWORDS:

• Friction stir welding
• dissimilar weld
• residual stress
• aluminium alloy
• stainless steel

Disclosure statement

No potential conflict of interest was reported by the authors.

ORCID

Yoshihiko Uematsu http://orcid.org/0000-0003-4161-3738