Structure and dynamic response of radiative diffusion flames

Nitrogen-diluted hydrogen burning in air is modeled numerically using a constant density and one-step reaction model in a plane two-dimensional counterflow configuration. An optically thin assumption is used to investigate the effects of radiation on the dynamics, structure, and extinction of diffusion flames. While there exist dual steady-state extinction limits for the 1D radiative flame response, it is found that as the 1D radiative extinction point is approached the 1D low-stretch diffusion flame exhibits oscillatory response, even with sub-unity Lewis number fuel. These radiation-induced limit cycle oscillations are found to have increasing amplitude and decreasing frequency as the stretch rate is reduced. Flame oscillation eventually leads to permanent extinction at the stretch rate which is larger than the steady-state radiative extinction value. Along the 1D radiative response curve, the transition from 1D flame to 2D structure and the differences in the resulting 2D flame patterns are also examined using a variety of initial profiles, with special emphasis on the comparison of using the initial profiles with and without a flame edge. Similar to the previous studies on the high-stretch adiabatic edge flames using the same configuration, the high-stretch radiative flames are found to resist 1D blow-off quenching through various 2D structures, including propagating front and steady cellular flames for initial profiles with and without flame edges. For all initial profiles studied, the low-stretch radiative flames are also found to exhibit different 2D flame phenomena near the 1D radiative extinction limit, such as transient cellular structures, steady cellular structures, and pulsating ignition fronts. Although the results demonstrate the presence of low-stretch and high-stretch 2D bifurcation branches close to the corresponding 1D extinction limits irrespective of the initial profile used, particular 2D flame structures in certain stretch rate range are initial profile dependent. The existence of two-dimensional flame structures beyond the 1D steady-state radiative extinction limit suggests that the flammable range is expanded as compared to that predicted by the 1D model. Hence, multi-dimensional flame patterns need to be accounted for when determining the flammability limits for a given system.

Keywords: :

• Flame instabilities
• Diffusional-thermal instability
• Flame radiation
• Cellular flames
• Flame extinction limits

Acknowledgement

This material is based upon work supported by the National Science Foundation under Grant No. 0119073. JRN would like to acknowledge the fellowship support by the National Center for Microgravity Research on Fluids and Combustion.

Notes

^§ http://mae1.cwru.edu/mae/Pages/Facilities/CDL/CDL_CTM_Edge_Flames_Movies.html