Abstract
Two new 5‐substituted 1,3,4‐thiadiazole‐2‐carboxylate esters have been synthesized via ring closure of appropriate tricarbonyl precursors using Lawesson's reagent. The chemistry described is the first report of such methodology in the organic literature. The new materials display broad smectic C phases and show considerable potential for use in electrooptic display devices.
1. Introduction
A survey of the liquid crystal literature reveals that a large number of mesogenic 1,3,4‐thiadizoles have been synthesized, although the chemical structures of these materials show very little variation. Substituents that have been incorporated at the 2‐ and 5‐ positions of the 1,3,4‐thiadiazole ring include: (a) two aryl units, (b) an alkyl (or cycloalkyl) and an aryl unit, (c) two cycloalkyl units, (d) an alkyl and an amino‐based unit (azo, amide or Schiff's base), (e) a perfluoroalkyl and an aryl unit and (f) an aryl and an amino unit (azo, amide or Schiff's base). Examples of such mesogens Citation1–10 are shown in figure (I–V).
This lack of structural variation is clearly related to the ease of synthesis of these units and the limitations of synthetic methodology in the literature. 1,3,4‐Thiadiazoles substituted at the 2‐ and 5‐positions with alkyl, cycloalkyl and aryl units are typically synthesized by the cyclization of diacylhydrazides (VI) using a source of sulphur such as phosphorus pentasulphide or Lawesson's reagent (figure ) Citation11.
1,3,4‐Thiadiazoles with nitrogen‐based linkers (amides, Schiff's bases or azo groups) at the 2‐position have been recently synthesized by Parra and co‐workers Citation6–10. These materials are derived from 2‐amino‐1,3,4‐thiadiazoles that are obtained via cyclization of the requisite thiosemicarbazides using either sulphuric acid or acetyl chloride in combination with HCl.
In order to synthesize 1,3,4‐thiadiazoles that are more thermally and/or photochemically stable and are more conducive Citation12, 13 to smectic C phase formation, we have developed a new methodology for the preparation of 1,3,4‐thiadiazole‐2‐carboxylate esters.
In 1982 Tanaka et al. reported the cyclization of ethoxalylaminoacetophenone (VIII) with phosphorus pentasulphide to give ethyl 5‐phenyl‐2‐thiazolecarboxylate (IX) (figure ) Citation14.
We postulated that analogous ethyl oxalyl diazanes might be cyclized to give 1,3,4‐thiadiazole‐2‐carboxylate esters under similar conditions. Instead of using phosphorus pentasulphide as a source of sulphur we chose Lawesson's reagent Citation11 due to its greater reliability and ease of workup. Once cyclized, we expected to be able to saponify the esters and esterify the resulting carboxylate salts with appropriate phenols to give the desired target materials.
2. Synthetic discussion
The synthetic schemes used to prepare the two target materials (7 and 13) are shown below (Schemes and ).
Scheme 1. Synthesis of (S)‐1‐methylheptyl 4‐[5‐(4‐octyloxyphenyl)‐1,3,4‐thiadiazol‐2‐ylcarbonyloxy]benzoate.
Scheme 2. Synthesis of (S)‐4‐(1‐methylheptyloxy)phenyl 5‐(4‐dodecyloxyphenyl)‐1,3,4‐thiadiazol‐2‐ylcarboxylate.
The preparation of 2 utilized the standard Williamson ether synthesis Citation15. Hydrazides 3 and 9 were obtained by reaction of esters 2 and 8 respectively with hydrazine in ethanol Citation16. Synthesis of the ethyl oxalyl diazanes 4 and 10 was accomplished by reaction of 3 and 9 respectively with ethyl oxalyl chloride in THF and triethylamine. Cyclization of 4 and 10 using Lawesson's reagent at room temperature gave excellent yields of the purified 1,3,4‐thiadiazole‐2‐carboxylate esters 5 and 11, respectively. Saponification of 5 and 11 gave sodium salts 6 and 12, respectively. These sodium salts are unstable when exposed to high vacuum for extended periods of time and readily decarboxylate once all traces of water have been removed by the drying process. Conversion of 6 and 12 to the acid chlorides followed by in situ esterification gave the target materials 7 and 13, respectively. Optimization of the esterification step is currently being undertaken in our laboratory.
3. Physical properties
The transition temperatures of the two final products 7 and 13 are as follows:
7 Transitions (°C) Cr 67.3 SmCA* 82.5 SmC* 115.9 SmA* 142.4 Iso. Liq.
13 Transitions (°C): Cr 74.8 SmC* 126.9 N* 127.4 Iso. Liq.
Full experimental details and physical studies will shortly be reported in the journal Liquid Crystals.
4. Experimental
4.1. (S)‐1‐Methylheptyl 4‐[5‐(4‐octyloxphenyl)‐1,3,4‐thiadiazol‐2‐ylcarbonyloxy]benzoate (7)
6 (0.98 g, 2.7 mmol) was suspended in anhydrous THF (20 mL) and anhydrous DMF (1 drop). The suspension was stirred vigorously and oxalyl chloride (0.2 mL, d 1.222 g/mL, 1.8 mmol) was added dropwise over 1 min. at room temperature. Once the evolution of gas had ceased, (S)‐1‐methylheptyl 4‐hydroxybenzoate (0.69 g, 2.8 mmol) was added and the reaction was stirred vigorously. Anhydrous triethylamine (0.4 mL, d 0.726 g/mL, 3 mmol) was then added dropwise over 10 min. After 4 h. the triethylamine hydrochloride was filtered off and the resulting solution was stirred with an excess of ethanol (20 mL). The solvent was removed in vacuo and the crude product was purified by column chromatography [silica gel: ethyl acetate / petroleum ether, 1:9] to afford a yellow powder, which was crystallized from petroleum ether and dried in a desiccator. A white powder was obtained. Yield 0.29 g (28%). Transitions (°C) Cr 67.3 SmCA* 82.5 SmC* 115.9 SmA* 142.4 Iso. Liq. (Rec. 15°C). 1H NMR (CDCl3) δ 0.88 (t, 3H, J = 6.0Hz), 1.20–1.43 (m, 18H), 1.35 (d, 3H, J = 6.3Hz), 1.43–1.77 (m, 2H), 1.83 (quint, 2H, J = 7.5Hz), 4.04 (t, 2H, J = 6.6Hz), 5.16 (sext, 1H, J = 6.0Hz), 7.01 (d, 2H, J = 9.0Hz), 7.38 (d, 2H, J = 9.0Hz), 8.00 (d, 2H, J = 9.0Hz), 8.15 (d, 2H, J = 9.0Hz). 13C NMR (CDCl3) δ 173.59, 165.37, 162.82, 157.64, 157.20, 153.57, 131.50, 130.37, 129.57, 121.51, 121.50, 115.48, 72.33, 68.59, 36.20, 31.96, 31.90, 29.48, 29.38, 29.32, 29.23, 26.14, 25.57, 22.82, 22.76, 20.24, 14.24, 14.23. Anal. Calcd for C32H42N2O5S: C, 67.82; H, 7.47; N, 4.94; S, 5.66. Found: C, 67.36; H, 7.27; N, 5.12; S, 5.55.
4.2. (S)‐4‐(1‐Methylheptyloxy)phenyl 5‐(4‐dodecyloxyphenyl)‐1,3,4‐thiadiazol‐2‐ylcarboxylate (13)
12 (0.89 g, 2.2 mmol) was suspended in anhydrous THF (20 mL) and anhydrous DMF (1 drop). The suspension was stirred vigorously and oxalyl chloride (0.2 mL, d 1.455 g/mL, 2 mmol) was added dropwise over 1 min. at room temperature. Once the evolution of gas had ceased, (S)‐4‐(l‐methylheptyloxyl)phenol (0.46 g, 2.1 mmol) was added and stirred vigorously. Anhydrous triethylamine (0.3 mL, d 0.726 g/mL, 2 mmol) was then added dropwise over 10 min. After 4 h. the triethylamine hydrochloride was filtered off and the resulting solution was stirred with an excess of ethanol (20 mL). The solvent was removed in vacuo and the crude product was purified by column chromatography [silica gel: ethyl acetate / petroleum ether, 1:9] to afford a yellow powder which was crystallized from petroleum ether and dried in a desiccator. A white powder was obtained. Yield 0.48 g (40%). Transitions (°C): Cr 74.8 SmC* 126.9 N* 127.4 Iso. Liq. (Rec. 58.7°C). 1H NMR (CDCl3) δ 0.87 (t, 6H, J = 6.0Hz), 1.08–1.61 (m, 32H), 1.31 (d, 3H, J = 6.0Hz), 1.80 (quint, 2H, J = 6.9Hz), 4.02 (t, 2H, J = 6.6Hz), 4.33 (sext, 1H, J = 6.0Hz), 6.92 (d, 2H, J = 9.0Hz), 6.99 (d, 2H, J = 9.0Hz), 7.19 (d, 2H, J = 9.0Hz), 7.97 (d, 2H, J = 9.0Hz). 13C NMR (CDCl3) δ 173.21, 162.68, 158.82, 158.02, 156.69, 143.52, 130.29, 122.26, 121.76, 116.65, 115.42, 74.65, 68.55, 36.61, 32.08, 31.96, 29.80, 29.51, 29.43, 29.24, 26.12, 25.68, 22.85, 22.76, 19.85, 14.25. Anal. Calcd for C35H50N2O4S: C, 70.67; H, 8.47; N, 4.71; S, 5.39. Found: C, 70.49; H, 8.64; N, 4.87; S, 5.61.
References
- S‐I. Sugita S. Toda T. Teraji A. Murayama M. Ishikawa 1993 Mol. Cryst. Liq. Cryst. 226 7 12
- S.‐I. Sugita S. Toda T. Teraji 1993 Mol. Cryst. Liq. Cryst. 237 33 38
- R. Lunkwitz C. Tschierske A. Langhoff F. Gieβelmann P. Zugenmaier 1997 J. Mater. Chem. 7 1713 1721
- W. Schafer U. Rosenfeld H. Zaschke H. Stettin H. Kresse 1989 J. Prakt. Chem. 331 631 636
- K. Zab D. Joachimi E. Novotna S. Diele C. Tschierske 1995 Liq. Cryst. 18 631 637
- M. Parra J. Belmar H. Zunza C. Zuniga S. Villouta R. Martinez 1993 Bol. Soc. Chil. Quim. 38 325 330
- M. Parra J. Belmar S. Villouta R. Martinez C. Zuniga H. Zunza 1995 Bol. Soc. Chil. Quim. 40 175 182
- M. Parra J. Belmar H. Zunza C. Zuniga S. Villouta R. Martinez 1995 J. Prakt. Chem. 337 325 327
- M. Parra G. Fuentes V. Vera S. H. Villouta S. Hernandez 1995 Bol. Soc. Chil. Quim. 40 455 460
- M. Parra S. Villouta V. Vera J. Belmar C. Zúñiga H. Zunza 1997 Z. Naturforsch., B: Chem. Sci. 52 1533 1538
- M. Jesberger T. P. Davis L. Barner 2003 Synthesis 1929 1958
- J. W. Goodby 1997 Mol. Cryst. Liq. Cryst. 292 245 263
- J. W. Goodby 1991 Properties and structures of ferroelectric liquid crystals. In Ferroelectric liquid crystals G. W. Taylor (Ed.) Gordon and Breach 99 248
- C. Tanaka K. Nasu N. Yamamoto M. Shibata 1982 Chem. Pharm. Bull. 30 4195 4198
- H. H. Freedman R. A. Dubois 1975 Tetrahedron Lett. 3251 3254
- S. R. Sandler W. Karo 1983 Hydrazine derivatives, hydrazones, and hydrazides. In Organic functional group preparations H. H. Wasserman (Ed.) Academic Press 434 465