Large-scale flow structures in a planar offset attaching jet with a co-flowing wall jet

Abstract

Conditional averaging techniques were used to examine the periodic motions that were observed in flows consisting of an offset planar jet and a co-flowing planar wall jet. The offset jet is one jet height (H_j) away from the wall and has a Reynolds number of approximately 40, 000, based on H_j and flow-rate averaged velocity U_o; for the co-flowing jets, different heights (i.e., 0.18H_j and 0.5H_j) and velocities (i.e., 0.56U_o and 0.36U_o) were considered. The flows had periodic motions with frequencies fH_j/U_o = 0.28 and 0.49 or fH_c/U_o = 0.23 and 0.25, where H_c is the distance between the jets. The periodic motions were present in both the inner shear layer of the offset jet above the re-circulation region and the outer shear layer of the wall jet below the re-circulation region. The motions from the inner shear layer of the offset jet persisted in the shear layer that formed downstream of the re-circulating region. There were periodic motions in the outer shear layer of the offset jet particularly in the flow with the smaller wall jet. The relative contribution of the motions to the total fluctuations increased as the flow evolved downstream reaching a maximum approximately 4H_c downstream of the flow exit. The relative contribution of the periodic motions to the turbulent fluctuations was similar in the two flows but the periodic motions had a much larger impact on the near-wall velocity and pressure fluctuations in the flow with the smaller wall jet due to the trajectory of the periodic structures, the distance of the periodic structures to the wall and the size of these structures.

Keywords:

• offset attaching jet
• co-flowing jets
• large-scale structures

Acknowledgements

The authors wish to acknowledge Ms L. C. Ofiara for her assistance in preparing the manuscript .

Additional information

Funding

This work was funded by the Natural Sciences and Engineering Research Council of Canada.