Stabilisation of Ce-Cu-Fe amorphous alloys by addition of Al

Abstract

The present work describes the formation of amorphous alloys in the (Al_1−xCe_x)₆₂Cu₂₅Fe₁₃ quaternary system (0 ≤ x ≤ 1). When the amount of Ce falls in the range 0.67 ≤ x ≤ 0.83, the alloys obtained exhibit a completely amorphous structure confirmed by powder X-ray diffraction. Otherwise, at compositions x = 0.5, 0.58, 0.92 and 1, a primary crystalline phase forms together with an amorphous matrix. The crystallisation temperature (T_x) decreases with increasing Ce content, varying from 593 K for x = 0.5–383 K for x = 1. Composition x = 0.75 is considered as the best glass former, exhibiting a large supercooled liquid region of 40 K width that precedes crystallisation. In order to form bulk amorphous alloys, ribbons with this later composition were consolidated into few millimetre thick discs using pulsed electric current sintering at different temperatures, yet preserving the amorphous structure. Meanwhile, increasing temperature above 483 K triggers crystallisation of a primary phase isostructural to AlCe₃. Further increase in the temperature up to 573 K yields a higher fraction of the crystalline phase. Testing mechanical properties, using nanoindentation, revealed that both elastic modulus (E) and hardness (H) depend on the Al content, ranging from E = 85.6 ± 3.7 GPa and H = 6.2 ± 0.7 GPa for x = 0.5 down to E = 39.8 ± 1.0 GPa and H = 3.1 ± 0.2 GPa for x = 0.92.

Keywords:

• Metallic glasses
• rare-earths
• sintering
• stability
• crystallisation

Acknowledgements

The present study was performed in the frame of a bilateral French–Slovene collaborative programme financed by CNRS and the Slovenian Research Agency, respectively. B. Skela and B. Ambrožič (Jozef Stefan Institute, Ljubljana) are acknowledged for providing assistance with the experimental part and microstructural analysis, respectively. J. Zavašnik (Jozef Stefan Institute, Ljubljana) is thanked for discussions regarding the principles of TEM analysis.