Characterization of Beryllium Particles from CAlSiFrit

Abstract

Aluminum smelters produce in excess thousand of tons of spent pot lining (SPL) each year. CAlSiFrit technology is a recycling process in which spent pot lining (SPL) is recovered and transformed into commercial value-added products. Since SPL contains beryllium (Be), exposures encountered by workers may result in adverse effects. This study aimed to establish the level at which Be is present in the CAlSiFrit and to determine the chemical and physical characteristics of the Be-containing particles. Three samples of CAlSiFrit powder supplied by the recycling industry were analyzed using several methods in order to (1) detect and characterize Be-containing particles, (2) identify the Be chemical form, and (3) quantify the amount of other major chemical elements present. These methods were: inductively coupled plasma–mass spectrometry, instrumental neutron activation analysis, time-of-flight secondary-ion mass spectrometry (TOF-SIMS), analytical transmission electron microscopy (ATEM), and x-ray diffraction. Results show that the three samples have a similar chemical composition, with high concentrations, of Si, Ca, Al, Na, F, Fe, K, Mg, and Ti, in decreasing order. Be concentrations were low and totaled less than 3 ppm. The size of the areas where Be was detected by TOF-SIMS is approximately 0.3 μm or less in diameter. A large quantity of oxygen in the particles of dusts was observed. As the majority of elements present have a great affinity for oxygen, the presence of oxygen indicates that these elements are probably oxides. Finally, the particle size varied from approximately 0.05 to 1 μm. This is consistent with the interpretation of the TOF-SIMS results that suggest a size of approximately 0.3 μm or less for the particles containing Be. These results are important from the perspective that thousands of tons of CAlSiFrit, a supplementary cement material, might be produced and used.

This study was funded by Nova Pb, St. Constant, Quebec, Canada.