The effect of grinding circuit efficiency on the grade and recovery of copper and molybdenum concentrates

ABSTRACT

The efficiency of grinding and flotation process in copper-molybdenum processing circuit, largely affected by performance of thickeners and hydrocyclones devices. The goal of this paper is to investigate the effect of the rate-limiting factors on the performance of these devices and consequently on grinding and separation efficiency of the molybdenum processing circuit. So, a full process mineralogical study have been carried out on outputs of thickeners and hydrocyclone of the molybdenite flotation circuit. According to the results, coarse-grained fractions (>50 μm) of the planar molybdenite will not necessarily be recovered by thickener and hydrocyclones. This is especially true for hydrocyclones when the inlet-load rate is high, i.e., the erroneous discharge of planar molybdenite particles from the overflow of hydrocyclone, as well as their floatability in the thickener overflow, can be attributed to the effect of particle shape and size. This issue harms the grade and recovery of flotation due to the increase in the amount of circulating load (regrinding) and consequently the generation of fine particles (<10 μm) in the hydrocyclone-milling circuit. On the other hand, the almost spherical particles of copper minerals, as well as the nonplanar molybdenite fine-grained particles, are easily removed from the hydrocyclone underflow or settled in thickeners. The introduction of copper mineral particles into molybdenum concentrate and vice versa has reduced the quality of the produced concentrate and undesirable flotation performance.

KEYWORDS:

• Molybdenite processing circuit
• thickener
• hydrocyclone
• process mineralogy
• sungun copper complex

Acknowledgements

This research is funded by the Research copper – molybdenum processing complex of Sungun.

Disclosure statement

No potential conflict of interest was reported by the authors.