The effect of a roundabout corridor's design on selecting the optimal crosswalk location: A multi-objective impact analysis

ABSTRACT

Crosswalks located at mid-block segment between roundabouts can provide a good balance among delay, carbon dioxide (CO₂) emissions, and relative difference between vehicles and pedestrians speed. However, when considering local pollutant criteria, the optimal crosswalk location may be different to that obtained for CO₂. This paper described a multi-objective analysis of pedestrian crosswalk locations, with the objectives of minimizing delay, emissions, and relative difference between vehicles and pedestrians speed. Accounting for the difference between global (e.g., CO₂) and local pollutants (monoxide carbon, nitrogen oxides, and hydrocarbons) was one the main considerations of this work. Vehicle activity along with traffic and pedestrian flows data at six roundabout corridors in Portugal, one in Spain, and one in the United States were collected and extracted. A simulation environment using VISSIM, Vehicle Specific Power, and Surrogate Safety Assessment Model models was used to evaluate traffic operations along the sites. The Fast Non-Dominated Sorting Genetic Algorithm (NSGA-II) was implemented to further search optimal crosswalk locations. The results yielded improvements to both delay and emissions by using site-optimized crosswalks. The findings also revealed that the spacing between intersections widely influenced the optimal crosswalk location along a mid-block section. If the spacing is low (<100 m), the crosswalk location will be approximately in 20%–30% of the spacing length. For spacing values between 140 and 200 m, crosswalks would be located at the midway position. When a specific pollutant criterion was considered, no significant differences were observed among optimal crosswalk data sets.

KEYWORDS:

• CO₂
• crosswalks
• local pollutants
• multi-objective optimization
• roundabout corridors
• spacing

Funding

This work is financed by ERDF Funds through the Operational Program Competitiveness and Internationalization – COMPETE 2020 and by National Funds through FCT – Foundation for Science and Technology within the scope of the POCI–01–0145–FEDER–16740 project.