Investigating correlations between crack width, corrosion level and anchorage capacity

Abstract

In assessing existing structures, inspection results need to be linked to the effects on load-carrying capacity; to provide such information, this study has investigated the correlation between splitting crack width, corrosion level and anchorage capacity. The study was based on 13 reinforced concrete beams that had been exposed to natural corrosion for 32 years, 11 beams with splitting cracks and 2 without. The crack pattern and widths were documented before undergoing structural testing of anchorage capacity. Thereafter, the reinforcement bars were extracted and their corrosion levels measured using two methods, gravimetric weight loss and 3D scanning. The corrosion level from the weight loss method was approximately twice as large; possible reasons are horizontal or subsurface corrosion pits, and the cleaning method. Further, for the same corrosion level, the specimens in this study had much larger crack widths and slightly lower bond capacity than the artificially corroded tests in the literature; a possible reason is that these specimens had been subjected to combined corrosion and freezing. However, the corrosion level and reduction in bond capacity related to crack width were both lower in the present than in previous studies in the literature. Thus, by formulating a damage indicator from the damage visible in the form of crack widths from artificial test data, the structural capacity is estimated to be on the safe side.

Keywords:

• Corrosion
• bond
• anchorage
• crack width
• pitting
• inspection
• 3D optical scanning

Acknowledgements

This research study was undertaken at Chalmers University of Technology, Division of Structural Engineering, Concrete Structures. The authors would like to gratefully acknowledge the funding by the Swedish Transport Administration (Trafikverket).