Emulsion Inversion in an Oil‐Surfactant‐Water System Based on Model Naphthenic Acids under Alkaline Conditions

Abstract

Emulsion inversion has been studied in a system based on oil (toluene/heptane), 5β‐cholanic acid, and an alkaline brine solution by varying the concentration of sodium hydroxide. At an intermediate pH w/o emulsions were formed, and in the high pH region o/w emulsions were formed. Emulsion inversion occurred in the pH range 8.5–10. The w/o emulsions were consistently more stable compared to the o/w emulsions. Increasing the amount of acid enhanced the stability of the emulsions. Maximum stability was observed close to pH 8, where the ratio between the undissociated and dissociated acid was approximately 1.5. From light microscopy, it can be seen that the emulsions are stabilized by a liquid gel phase. At equilibrium the system consists of an oil phase, a liquid gel phase, and an aqueous phase. Increasing the oil fraction eventually gave only w/o emulsions in the pH range between 7 and 14. For these emulsions, no obvious difference in stability was observed at pH 8, while the stability of the emulsions in the high pH region was significantly enhanced. An increase of the ratio between toluene and heptane gave no obvious difference in either stability or type of emulsion while varying the pH. Use of a less lipophilic acid, such as 4‐octylbenzoic acid, gave very unstable w/o emulsions in the intermediate pH region, while stable o/w emulsions were found in the high pH region.

Keywords:

• Naphthenic acids
• emulsion inversion
• emulsion stability
• lamellar liquid structures
• pH

Acknowledgments

We would like to thank the industrial oil company consortium (JIP 1) for financial support. Funding from Norwegian Research Council (Strategiska omställnings program, SOP) is also gratefully acknowledged.