An Investigation of Milk Powders Produced by a Laboratory-Scale Spray Dryer

ABSTRACT

A mini spray dryer has been used to investigate morphological changes that occur to milk particles during the spray drying process. We have found that the mini spray dryer is ideal for such investigations, because phenomena such as skin and vacuole formation in particles can be analyzed without the added complication of particle agglomeration, which only occurs in much larger spray dryers where particle number concentrations are higher. We have confirmed observations made by various researchers that the bulk density of spray-dried milk powder is greatly affected by the drying temperature, due to the strong influence of the latter on the porosity of the particles. In addition, we have attempted to explain observations made by various workers that fat accumulates preferentially at the surface of a particle during drying by postulating that fluid fat is transported towards the surface, via a network of cracks and pores, by the development of a vacuole overpressure which is also responsible for the inflation of the particle. Finally, we have shown that milk powders can be spray dried a second time, by reconstitution with water, with no change to the thermodynamic characteristics of the resultant powder. Thus, milk concentrates for spray drying research can be prepared from already-spray-dried milk powders rather than using the more arduous evaporation method to concentrate unprocessed milk.

Keywords:

• Particle morphology
• Bulk density
• Differential scanning calorimetry
• Skim milk
• Whole milk

ACKNOWLEDGEMENTS

We thank Mr. K. Kota (Chemical Engineering Department) and Mr. T. Shearing (Department of Mechanical Engineering) for their technical assistance. This work has been supported by an Australian Research Council Large Grant.