Abstract
The top-blown oxygen jet behaviours at different stagnation temperatures in converter steelmaking process were investigated by using numerical simulation technique. The multiphase flow in top-blown converter with four-hole lance was computed. The results show that with the increasing stagnation temperature of the supersonic oxygen jet, the velocity and static temperature of the jet increase, while the potential core length of the jet shortens. The penetrability of the oxygen jet injected from a four-hole top-blown lance is improved with the increasing stagnation temperature of the jet from 300 to 900 K, while the penetrability declines with the further increase in the stagnation temperature from 900 to 1200 K. Although the penetration depth and impact area corresponding to the oxygen jet with stagnation temperature of 1200 K are smaller than those of 900 K, the horizontal velocity of liquid steel increases with the increasing stagnation temperature due to the increase in the intersection and interference of jet flow, which further enhances the flow of the liquid phase at the interface of gas and liquid and promotes the mixing conditions in converter bath.
On a examiné les comportements d’un jet d’oxygène à soufflage par le haut à différentes températures d’équilibre lors du procédé de fabrication de l’acier par convertisseur, en utilisant une technique de simulation numérique. On a calculé l’écoulement polyphasique dans le convertisseur à soufflage par le haut avec lance à quatre trous. Les résultats montrent qu’avec l’augmentation de la température d’équilibre du jet d’oxygène supersonique, la température statique et la vélocité du jet augmentent, alors que la longueur potentielle du noyau du jet est raccourcie. La capacité de pénétration du jet d’oxygène injecté s’améliore avec l’augmentation de la température d’équilibre du jet de 300 à 900 K, mais elle s’abaisse avec une augmentation additionnelle de la température d’équilibre de 900 à 1200 K. Bien que la profondeur de pénétration et la superficie de l’impact correspondant au jet d’oxygène avec température d’équilibre à 1200 K soient plus petites qu’à 900 K, la vélocité horizontale de l’acier liquide augmente avec une augmentation de la température d’équilibre. Cela est dû à l’augmentation de l’intersection et à l’interférence de l’écoulement du jet, ce qui améliore davantage l’écoulement de la phase liquide à l’interface gaz et liquide et encourage les conditions de mélange dans le bain du convertisseur.
Acknowledgements
The authors would like to express sincere thanks to Dr Cheng-bin SHI, Pohang University of Science and Technology (POSTECH), for his valuable guidance and help reviewing manuscript.