![Sample our Physical Sciences journals, sign in here to start your FREE access for 14 days]({"type":"image" , "src" : "/sda/110819/TOC-Subject-Sample-2021-Physical-Sciences.jpg"})
Abstract
The gas analysis method according to EN 717 part 2 is a well-known technique to measure the formaldehyde emission of plywood and coated wood-based materials for quality control purposes. There is an increasing interest to apply this method also for uncoated wood-based panels compared to the perforator method (EN 120: 1992) owing to many reasons. As there is still limited experience in testing particleboard with this method, it is the aim of this study to evaluate the effect of some parameters to ensure correct and precise testing using the gas analysis method. Furthermore, the study aimed to show how the m.c. of panels before testing affects the Gm, and to calculate an m.c. correction factor from these results for particleboard with modern bonding systems at a low emission level. Gas analysis value and m.c. show a very good correlation. Based on this correlation an m.c. correction factor can be determined, which facilitates an m.c. correction of Gm data. This may help to improve the quality of Gm data for quality control and data comparison (i.e. for round robin tests). Combining the sampling for hour 3 and 4 as well as 2, 3 and 4 has no significant effect on the level of formaldehyde emission tested. Also the accuracy of testing was not reduced. Consequently, the change in sampling procedure may lead to a reduction on the required number of water analyses needing to be performed in the laboratory, and therefore to a reduction in consumption of chemical consumables and expenditure of human labour. The reduction of overpressure during gas analysis did not have a major effect on the values as such, but increased the coefficient of variation. Also, an increase in air flowrate did not affect the Gm at lower emission levels.
Keywords: