Effectiveness of the Gaussian Beam Model in Predicting Sar Distributions from the Lucite Cone Applicator

Abstract

The Gaussian beam model (GBM) has been shown to be a successful tool in the development of the current sheet applicator. As a result, the effectiveness of the GBM is investigated in single and dual array applications of the lucite cone applicator (LCA). The LCA is a modified water-filled waveguide applicator with an improved effective field size (EFS > 64 cm², aperture 10 cm × 10 cm). The GB-source parameters were calculated from the emanating E-field of a single LCA. The SAR distribution from a single LCA was measured by E-field scanning and thermographic (TG) imaging, and compared with the GB-predicted SAR distribution. Deviations in theprincipal planes were found to be less than 5%. TG-measured and GB-predicted SAR distributions from three different dual LCA configurations were compared and evaluated. When water was used as intermedium between LCAs and phantom, a maximum SAR difference of27% xwas calculated. In the absence of water as intermedium, this difference increased to 44%. These large deviations were only found in areas where the measured SAR distribution was disturbed due to antenna interactions. The average SAR differences with and without water as intermedium were 7% respectively 11%, indicating hat the GBM can provide good qualitative information about the SAR distribution of dual LCA-arrays.

Key Words:

• Superficial hyperthermia
• microwave antenna
• Gaussian beam modelling
• SAR distribution