REFERENCES
- Ait El Menceur, M. O., P.Pudlo, P.Gorce, A.Thevenon, and F.-X.Lepoutre. 2008. “Alternative Movement Identification in the Automobile Ingress and Egress for Young and Elderly Population with or without Prostheses.” International Journal of Industrial Ergonomics39 (11–12): 1078–1087.
- Andreoni, G., M.Rabuffetti, and A.Pedotti. 2004. “Kinematics of Head-Trunk Movements while Entering and Exiting a Car.” Ergonomics47 (3): 343–359.
- Bahrami, F., R.Riener, P.Jabedar-Maralani, and G.Schmidt. 2000. “Biomechanical Analysis of Sit-to-Stand Transfer in Healthy and Paraplegic Subjects.” Clinical Biomechanics15 (2): 123–133.
- Causse, J.2011. “Analyse cinématique et dynamique du mouvement d'accessibilité à une automobile.” [Kinematic and Dynamic Analysis of Car Accessibility Movements.], PhD thesis, University Claude Bernard Lyon1.
- Causse, J., E.Chateauroux, G.Monnier, X.Wang, and L.Denninger. 2009. “Dynamic Analysis of Car Ingress/Egress Movement: An Experimental Protocol and Preliminary Results.” SAE International Journal of Passenger Cars-Mechanical Systems2 (1): 1633–1640.
- Causse, J., X.Wang, and L.Denninger. 2012. “An Experimental Investigation on the Requirement of Roof Height and Sill Width for Car Ingress and Egress.” Ergonomics55: 1596–1611.
- Chaffin, D., G.Andersson, and B.Martin. 2006. Occupational Biomechanics. 4th ed.New York: Wiley.
- Chateauroux, E., and X.Wang. 2010. “Car Egress Analysis of Younger and Older Drivers for Motion Simulation.” Applied Ergonomics42 (1): 169–177.
- Croce, U. D., A.Leardini, L.Chiari, and A.Cappozzo. 2005. “Human Movement Analysis Using Stereophotogrammetry: Part 4: Assessment of Anatomical Landmark Misplacement and Its Effects on Joint Kinematics.” Gait & Posture21 (2): 226–237.
- Debril, J.-F., P.Pudlo, M.Ait El Menceur, P.Gorce, and F.Lepoutre. 2007. “Human Articulation Efforts Estimation in the Automobile Vehicle Accessibility Movement – A Pilot Study.” In Digital Human Modeling, Volume 4561 of Lecture Notes in Computer Science, edited by V.Duffy, 23–32. Springer: Heidelberg.
- Delp, S. L.1990. “Surgery Simulation: A Computer Graphics System to Analyze and Design Musculoskeletal Reconstructions of the Lower Limb.” PhD thesis, Stanford University.
- Desroches, G., L.Cheze, and R.Dumas. 2010. “Expression of Joint Moment in the Joint Coordinate System.” Journal of Biomechanical Engineering132 (11): 114503.
- Doriot, N., and L.Chèze. 2004. “A Three-Dimensional Kinematic and Dynamic Study of the Lower Limb during the Stance Phase of Gait Using an Homogeneous Matrix Approach.” IEEE Transactions on Biomedical Engineering51 (1): 21–27.
- Dumas, R., L.Cheze, and J.-P.Verriest. 2007. “Adjustments to McConville et al. and Young et al. Body Segment Inertial Parameters.” Journal of Biomechanics40: 543–553.
- Eng, J. J., and D. A.Winter. 1995. “Kinetic Analysis of the Lower Limbs during Walking: What Information Can Be Gained from a Three-Dimensional Model?” Journal of Biomechanics28 (6): 753–758.
- Giacomin, J., and S.Quattrocolo. 1997. “An Analysis of Human Comfort When Entering and Exiting the Rear Seat of an Automobile.” Applied Ergonomics28: 397–406.
- Herriotts, P.2005. “Identification of Vehicle Design Requirements for Older Drivers.” Applied Ergonomics36 (3): 255–262.
- Hof, A. L.1996. “Scaling Gait Data to Body Size.” Gait & Posture4 (3): 222–223.
- Holden, J. P., and S. J.Stanhope. 1998. “The Effect of Variation in Knee Center Location Estimates on Net Knee Joint Moments.” Gait & Posture7 (1): 1–6.
- James, J.1985. Problems Experienced by Disabled and Elderly People Entering and Leaving Cars. Crowthorn, UK: Institute for Consumer Ergonomics and Transport and Road Research Laboratory.
- Kee, D., and W.Karwowski. 2001. “The Boundaries for Joint Angles of Isocomfort for Sitting and Standing Males Based on Perceived Comfort of Static Joint Postures.” Ergonomics44: 614–648.
- Keeley, D. W., G. D.Oliver, and C. P.Dougherty. 2012. “A Biomechanical Model Correlating Shoulder Kinetics to Pain in Young Baseball Pitchers.” Journal of Human Kinetics34 (1): 15–20.
- Monnier, G., X. Wang, and G. Beurier. 2007. “Coordination of Spine Degrees of Freedom during a Motion Reconstruction.” SAE International Conference and Exposition of Digital Human Modelling for Design and Engineering, SAE Paper 2007-01-2454.
- Monnier, G., E.Chateauroux, X.Wang, and G.Beurier. 2009. “Inverse Dynamic Reconstruction of Truck Cabin Ingress/Egress Motions.” SAE International Journal of Passenger Cars-Mechanical Systems2 (1): 1593–1599.
- Petzäll, J.1995. “The Design of Entrances of Taxis for Elderly and Disabled Passengers: An Experimental Study.” Applied Ergonomics26: 343–352.
- Rao, G., D.Amarantini, E.Berton, and D.Favier. 2006. “Influence of Body Segments' Parameters Estimation Models on Inverse Dynamics Solutions during Gait.” Journal of Biomechanics39 (8): 1531–1536.
- Ren, L., R. K.Jones, and D.Howard. 2008. “Whole Body Inverse Dynamics over a Complete Gait Cycle Based Only on Measured Kinematics.” Journal of Biomechanics41 (12): 2750–2759.
- Robert, T.2006. “Analyse biomécanique du maintien de l'équilibre debout suite à une accélération transitoire de la surface d'appui.” [Biomechanical Analysis of the Balance Recovery of Standing Human Following a Transitory Acceleration of the Supporting Surface.] PhD thesis, Institut National des Sciences Appliquées de Lyon.
- Robert, T., J.Causse, and G.Monnier. 2013. “Estimation of External Contact Loads Using an Inverse Dynamics and Optimization Approach: General Method and Application to Sit-to-Stand Maneuvers.” Journal of Biomechanics46 (13): 2220–2227.
- Robert, T., L.Cheze, R.Dumas, and J.-P.Verriest. 2007. “Validation of Net Joint Loads Calculated by Inverse Dynamics in Case of Complex Movements: Application to Balance Recovery Movements.” Journal of Biomechanics40: 2450–2456.
- SAE J1100. 2009. Motor Vehicle Dimensions. Warrendale, PA: SAE International.
- Silva, M., and J.Ambrosio. 2004. “Sensitivity of the Results Produced by the Inverse Dynamic Analysis of a Human Stride to Perturbed Input Data.” Gait & Posture19 (1): 35–49.
- Su, F. C., K. A.Lai, and W. H.Hong. 1998. “Rising from Chair after Total Knee Arthroplasty.” Clinical Biomechanics13 (3): 176–181.
- Vaughan, C. L., J. G.Hay, and J. G.Andrews. 1982. “Closed Loop Problems in Biomechanics. Part I – A Classification System.” Journal of Biomechanics15 (3): 197–200.
- Wang, X., N.Chevalot, G.Monnier, S.Ausejo, A.Suescun, and J.Celigueta. 2005. “Validation of a Model-Based Motion Reconstruction Method Developed in the Realman Project.” SAE Transactions Journal of Passenger Cars – Electronic and Electrical Systems114: 873–879.
- Wu, G., S.Siegler, P.Allard, C.Kirtley, A.Leardini, D.Rosenbaum, M.Whittle, D. D.D'Lima, L.Cristofolini, H.Witte, O.Schmid, and I.Stokes. 2002. “ISB Recommendation on Definitions of Joint Coordinate System of Various Joints for the Reporting of Human Joint Motion – Part 1: Ankle, Hip, and Spine.” Journal of Biomechanics35: 543–548.