References
- Wycisk E, Siddique S, Herzog D, et al. Fatigue performance of laser additive manufactured Ti–6Al–4 V in very high cycle fatigue regime up to 109 cycles. Frontiers Mater. 2015;2(72):1–8.
- Kim FH, Moylan SP. Literature review of metal additive manufacturing pores. National Institute of Standards and Technology. 2016. (NIST AMS; 100-16).
- Atkinson HV, Rickinson BA. Hot isostatic processing: The Adam Hilger series on new materials. Bristol: Series Editor J Woods; 1991.
- Lütjering G, Williams JC. Titanium. 2nd ed. Berlin Heidelberg: Springer; 2007.
- Tammas-Williams S, Withers PJ, Todd I, et al. Porosity regrowth during heat treatment of hot isostatically pressed additively manufactured titanium components. Scr Mater. 2016;122:72–76.
- Tammas-Williams S, Withers PJ, Todd I, et al. The effectiveness of hot isostatic pressing for closing porosity in titanium parts manufactured by selective electron beam melting. Metall Mater Trans A. 2016;47(5):1939–1946.
- Tammas-Williams S, Withers PJ, Todd I, et al. The influence of porosity on fatigue crack initiation in additively manufactured titanium components. Sci Rep. 2017;7(1):1–3.
- Schaak C, Tillmann W, Schaper M, et al. Process gas infiltration in Inconel 718 samples during SLM processing. RTejournal - Forum für Rapid Technologie. 2016;13(1):1–8.
- Pauzon C, Dubiez-Le Goff S, Forêt P, et al. Thermally induced porosity within HIPed Ti64 parts: effect of entrapped argon versus helium in L-PBF. Proceedings of EuroPM2019; 2019; Maastricht, Netherlands.
- Kosonen T, Kakko K, Kupi K. Evaluation of HIP-parameter effects on AM titanium Ti-6Al-4V. Paper presented at AeroMat19, 30th Conference and Exposition; 2019 May 6–8; Reno, NV.
- Swedish standards institute. Powder metallurgy – Hot isostatic pressing – argon detection using gas chromatography and mass spectrometry techniques. SS 118000:2018, Edition 1. Stockholm: Swedish Standards Institute; 2018.
- Lampman S. Wrought titanium and titanium alloys. ASM handbook volume 2: properties and selection: nonferrous alloys and special-purpose materials. 10th edition, ASM International; Materials Park, Ohio, 1992.
- Strandh E, Mellin P, Dubiez-Le Goff S, et al. Surface pick-up of argon during hot isostatic pressing of material built by laser powder bed fusion. Addit Manuf. 2021;38:101763.
- Shao S, Mahtabi MJ, Shamsaei N, et al. Solubility of argon in laser additive manufactured α-titanium under hot isostatic pressing condition. Comput Mater Sci. 2017;131:209–219.