Thermal Performance Analysis of Slug Flow in Square Microchannels

References

• M. R. Salimpour, M. Sharifhasan, and E. Shirani, “Constructal optimization of microchannel heat sinks with noncircular cross sections,” Heat Transfer Eng., vol. 34, no. 10, pp. 863–874, 2013.
   Web of Science ®Google Scholar
• D. B. Tuckerman and R. F. W. Pease, “High-performance heat sinking for VLSI,” IEEE Electron Device Lett., vol. 2, no. 5, pp. 126–129, 1981.
   Web of Science ®Google Scholar
• Y. Sui, C. J. Teo, P. S. Lee, Y. T. Chew, and C. Shu, “Fluid flow and heat transfer in wavy microchannels,” Int. J. Heat Mass Transfer, vol. 53, no. 13–14, pp. 2760–2772, 2010.
   Web of Science ®Google Scholar
• A. Bordbar, A. Taassob, and R. Kamali, “Diffusion and convection mixing of non‐Newtonian liquids in an optimized micromixer,” Can. J. Chem. Eng., vol. 96, no. 8, pp. 18290–1836, 2018.
   Web of Science ®Google Scholar
• T. İzci, M. Koz, and A. Koşar, “The effect of micro pin-fin shape on thermal and hydraulic performance of micro pin-fin heat sinks,” Heat Transfer Eng., vol. 36, no. 17, pp. 1447–1457, 2015.
   Web of Science ®Google Scholar
• A. Taassob, R. Kamali, and A. Bordbar, “Investigation of rarefied gas flow through bended microchannels,” Vacuum, vol. 151, pp. 197–204, 2018.
   Web of Science ®Google Scholar
• S. G. Kandlikar, “History, advances, and challenges in liquid flow and flow boiling heat transfer in microchannels: a critical review,” J. Heat Transfer, vol. 134, no. 3, pp. 034001–034015, 2012.
   Web of Science ®Google Scholar
• N. R. Rosaguti, D. F. Fletcher, and B. S. Haynes, “Low-Reynolds number heat transfer enhancement in sinusoidal channels,” Chem. Eng. Sci., vol. 62, no. 3, pp. 694–702, 2007.
   Web of Science ®Google Scholar
• L. J. Gong, K. Kota, W. Tao, and Y. Joshi, “Thermal performance of microchannels with wavy walls for electronics cooling,” IEEE Trans. Comp. Pack. Manuf. Technol., vol. 1, no. 7, pp. 1029–1035, 2011.
   Web of Science ®Google Scholar
• H. Ş. Aybar, M. Sharifpur, M. R. Azizian, M. Mehrabi, and J. P. Meyer, “A review of thermal conductivity models for nanofluids,” Heat Transfer Eng., vol. 36, no. 13, pp. 1085–1110, 2015.
   Web of Science ®Google Scholar
• H. Mori, “Two-Phase flow and boiling heat transfer in Small-diameter tubes,” Heat Transfer Eng., vol. 37, no. 7-8, pp. 686–695, 2016.
   Web of Science ®Google Scholar
• Y. S. Muzychka, E. J. Walsh, and P. Walsh, “Heat transfer enhancement using laminar gas-liquid segmented plug flows,” J. Heat Transfer, vol. 133, no. 4, pp. 041902, 2011.
   Web of Science ®Google Scholar
• A. Taassob, M. K. D. Manshadi, A. Bordbar, and R. Kamali, “Monodisperse non-Newtonian micro-droplet generation in a co-flow device,” J. Brazil. Soc. Mech. Sci. Eng., vol. 39, no. 6, pp. 2013–2021, 2017.
   Web of Science ®Google Scholar
• R. Gupta, D. F. Fletcher, and B. S. Haynes, “CFD modelling of flow and heat transfer in the Taylor flow regime,” Chem. Eng. Sci., vol. 65, no. 6, pp. 2094–2107, 2010.
   Web of Science ®Google Scholar
• A. Bordbar, A. Taassob, A. Zarnaghsh, and R. Kamali, “Slug flow in microchannels: numerical simulation and applications,” J. Ind. Eng. Chem., vol. 62, pp. 26–39, 2018.
   Web of Science ®Google Scholar
• Z. Che, T. N. Wong, and N. T. Nguyen, “Heat transfer in plug flow in cylindrical microcapillaries with constant surface heat flux,” Int. J. Thermal Sci., vol. 64, pp. 204–212, 2013.
   Web of Science ®Google Scholar
• A. R. Betz, and D. Attinger, “Can segmented flow enhance heat transfer in microchannel heat sinks?,” Int. J. Heat Mass Transfer, vol. 53, no. 19–20, pp. 3683–3691, 2010.
   Web of Science ®Google Scholar
• V. Talimi, Y. S. Muzychka, and S. Kocabiyik, “Slug flow heat transfer in square microchannels,” Int. J. Heat Mass Transfer, vol. 62, pp. 752–760, 2013.
   Web of Science ®Google Scholar
• J. Zhang, D. F. Fletcher, and W. Li, “Heat transfer and pressure drop characteristics of gas–liquid taylor flow in mini ducts of square and rectangular cross-sections,” Int. J. Heat Mass Transfer, vol. 103, pp. 45–56, 2016.
   Web of Science ®Google Scholar
• A. Asthana, I. Zinovik, C. Weinmueller, and D. Poulikakos, “Significant nusselt number increase in microchannels with a segmented flow of two immiscible liquids: an experimental study,” Int. J. Heat Mass Transfer, vol. 54, no. 7-8, pp. 1456–1464, 2011.
   Web of Science ®Google Scholar
• M. Fischer, D. Juric, and D. Poulikakos, “Large convective heat transfer enhancement in microchannels with a train of coflowing immiscible or colloidal droplets,” J. Heat Transfer, vol. 132, no. 11, pp. 112402–112402-10, 2010.
   Web of Science ®Google Scholar
• T. Bandara, S. C. Cheung, and G. Rosengarten, “Slug flow heat transfer in microchannels: a numerical study,” Comput. Thermal Sci. Int. J., vol. 7, no. 1, pp. 81–92, 2015.
   Web of Science ®Google Scholar
• Z. Che, T. N. Wong, N. T. Nguyen, and C. Yang, “Three dimensional features of convective heat transfer in droplet-based microchannel heat sinks,” Int. J. Heat Mass Transfer, vol. 86, pp. 455–464, 2015.
   Web of Science ®Google Scholar
• Z. Dai, Z. Guo, D. F. Fletcher, and B. S. Haynes, “Taylor flow heat transfer in microchannels—unification of liquid–liquid and gas–liquid results,” Chem. Eng. Sci., vol. 138, pp. 140–152, 2015.
   Web of Science ®Google Scholar
• A. Mehdizadeh, S. A. Sherif, and W. E. Lear, “Numerical simulation of thermofluid characteristics of two-phase slug flow in microchannels,” Int. J. Heat Mass Transfer, vol. 54, no. 15–16, pp. 3457–3465, 2011.
   Web of Science ®Google Scholar
• J. Zhang et al., “Fundamentals and applications of inertial microfluidics: a review,” Lab. Chip., vol. 16, no. 1, pp. 10–34, 2016.
   PubMed Web of Science ®Google Scholar
• A. N. Asadolahi, R. Gupta, D. F. Fletcher, and B. S. Haynes, “CFD approaches for the simulation of hydrodynamics and heat transfer in taylor flow,” Chem. Eng. Sci., vol. 66, no. 22, pp. 5575–5584, 2011.
   Web of Science ®Google Scholar
• J. U. Brackbill, D. B. Kothe, and C. Zemach, “A continuum method for modeling surface tension,” J. Comput. Phys., vol. 100, no. 2, pp. 335–354, 1992.
   Web of Science ®Google Scholar
• A. Bordbar, A. Taassob, D. Khojasteh, M. Marengo, and R. Kamali, “Maximum spreading and rebound of a droplet impacting onto a spherical surface at low weber numbers. Langmuir,” Langmuir, vol. 34, no. 17, pp. 5149–5158, 2018.
   PubMed Web of Science ®Google Scholar
• W. M. Kays, M. E. Crawford, and B. Weigand, Convective Heat and Mass Transfer, 4th ed. Maidenhead, Berkshire: McGraw-Hill Education, 2004.
   Google Scholar
• D. Khojasteh, S. M. Mousavi, and R. Kamali, “CFD analysis of newtonian and non-Newtonian droplets impinging on heated hydrophilic and hydrophobic surfaces,” Indian J. Phys., vol. 91, no. 5, pp. 513–520, 2017.
   Web of Science ®Google Scholar
• P. Aussillous, and D. Quéré, “Quick deposition of a fluid on the wall of a tube,” Phys. Fluids, vol. 12, no. 10, pp. 2367–2371, 2000.
   Web of Science ®Google Scholar
• Y. Han, and N. Shikazono, “Measurement of the liquid film thickness in micro tube slug flow,” Int. J. Heat Fluid Flow, vol. 30, no. 5, pp. 842–853, 2009.
   Web of Science ®Google Scholar
• V. Duclaux, C. Clanet, and D. Quéré, “The effects of gravity on the capillary instability in tubes,” J. Fluid Mechan., vol. 556, pp. 217–226, 2006.
   Web of Science ®Google Scholar
• F. Guo, and B. Chen, “Numerical study on taylor bubble formation in a micro-channel T-junction using VOF method,” Microgravity Sci. Technol., vol. 21, no. S1, pp. 51–58, 2009.
   Web of Science ®Google Scholar
• S. M. Mousavi, and E. Roohi, “Large eddy simulation of shock train in a convergent–divergent nozzle,” Int. J. Modern Phys. C, vol. 25, no. 04, pp. 1450003–1450027, 2014. no.
   Web of Science ®Google Scholar
• P. A. Walsh, E. J. Walsh, and Y. S. Muzychka, “Heat transfer model for gas–liquid slug flows under constant flux,” Int. J. Heat Mass Transfer, vol. 53, no. 15–16, pp. 3193–3201, 2010.
   Web of Science ®Google Scholar
• C. A. Stan, S. K. Tang, and G. M. Whitesides, “Independent control of drop size and velocity in microfluidic flow-focusing generators using variable temperature and flow rate,” Anal. Chem., vol. 81, no. 6, pp. 2399–2402, 2009.
   PubMed Web of Science ®Google Scholar
• S. S. Murshed, S. H. Tan, and N. T. Nguyen, “Temperature dependence of interfacial properties and viscosity of nanofluids for droplet-based microfluidics,” J. Phys. D Appl. Phys., vol. 41, no. 8, pp. 085502–085502-5, 2008.
   Web of Science ®Google Scholar
• J. Rostami, and A. Abbassi, “Conjugate heat transfer in a wavy microchannel using nanofluid by two-phase eulerian–lagrangian method,” Adv. Powder Technol., vol. 27, no. 1, pp. 9–18, 2016.
   Web of Science ®Google Scholar
• F. Oviedo-Tolentino, R. Romero-Méndez, A. Hernández-Guerrero, and B. Girón-Palomares, “Experimental study of fluid flow in the entrance of a sinusoidal channel,” Int. J. Heat Fluid Flow, vol. 29, no. 5, pp. 1233–1239, 2008.
   Web of Science ®Google Scholar
• V. Kumar, M. Aggarwal, and K. D. P. Nigam, “Mixing in curved tubes,” Chem. Eng. Sci., vol. 61, no. 17, pp. 5742–5753, 2006.
   Web of Science ®Google Scholar
• Z. Che, T. N. Wong, and N. T. Nguyen, “Heat transfer enhancement by recirculating flow within liquid plugs in microchannels,” Int. J. Heat Mass Transfer, vol. 55, no. 7-8, pp. 1947–1956, 2012.
   Web of Science ®Google Scholar