Influences of different reinforcement particles on performances of electroless composites

References

• D. Vojtěcha: ‘Properties of hard Ni-P-Al₂O₃ and Ni-P-SiC coatings on Al-based casting alloys’, Mater. Manuf. Process, 2009, 24, (7–8), 754–757.
   Google Scholar
• Y. Choi, D. U. Kim and B. Y. Kang: ‘Forming of the precision aluminum tube for a light weight propeller shaft’, J. Mech. Sci. Technol., 2013, 27, (11), 445–449.
   Web of Science ®Google Scholar
• A. R. Al-Samarai, Haftirman, K. R. Ahmad and Y. Al-Douri: ‘Effect of roughness of hypo-and hyper-eutectic Al-Si piston alloy on wear characteristics under lubrication’, Proc. Eng., 2013, 53, 616–623.
   Google Scholar
• C. Lin, S. S. Wu and S. l. Lu: ‘Dry sliding wear behavior of rheocast hypereutectic Al-Si alloys with different Fe contents’, Trans. Nonferrous Met. Soc. China, 2016, 26, 665–675.
   Web of Science ®Google Scholar
• S. K. Shaha, F. Czerwinski and W. Kasprzak: ‘Effect of Mn and heat treatment on improvements in static strength and low-cycle fatigue life of an Al-Si-Cu-Mg alloy’, Mater. Sci. Eng. A, 2016, 657, 441–452.
   Web of Science ®Google Scholar
• Y. W. Song, D. Y. Shan and E. H. Han: ‘High corrosion resistance multilayer nickel coatings on AZ91D magnesium alloys’, Surf. Eng., 2007, 23, (5), 329–333.
   Web of Science ®Google Scholar
• A. Hadipour, S. M. Monirvaghefi and M. E. Bahrololoom: ‘Electroless deposition of graded Ni-P coatings’, Surf. Eng., 2015, 31, (6), 399–405.
   Web of Science ®Google Scholar
• A. Hadipour and S. M. Monirvaghefi: ‘Comparison of H-Cr single layer and Ni-P/H-Cr duplex coating’, Surf. Eng., 2015, 31, (9), 666–672.
   Web of Science ®Google Scholar
• S. R. Anvari, S. M. Monirvaghefi and M. H. Enayati: ‘Wear characteristics of functionally graded nanocrystalline Ni-P coating’, Surf. Eng., 2015, 31, (9), 693–700.
   Web of Science ®Google Scholar
• S. Karthikeyan, P. A. Jeeva, S. Narayanan, K. N. Srinivasan and X. Hud: ‘Quantum mechanical approach for electroless plating process’, Surf. Eng., 2012, 28, (10), 743–746.
   Web of Science ®Google Scholar
• V. K. Bulasara, R. Uppaluri and M. K. Purkait: ‘Surface engineering characteristics of ultrasound assisted hypophosphite electroless plating baths’, Surf. Eng., 2013, 29, (7), 489–494.
   Web of Science ®Google Scholar
• Y. D. Yu, M. G. Li, G. Y. Wei and H. L. Ge: ‘Effects of pH values on electroless deposition of CoP films’, Surf. Eng., 2013, 29, (10), 767–771.
   Web of Science ®Google Scholar
• R. Soleimani, F. Mahboubi, M. Kazemi and S. Y. Arman: ‘Corrosion and tribological behaviour of electroless Ni-P/nano-SiC composite coating on aluminum 6061’, Surf. Eng., 2015, 31, (9), 741–721.
   Web of Science ®Google Scholar
• H. Zhang and R. L. Liu: ‘Study on properties of electroless (Ni-P)-Fe3O4 (nanometre) composite plated PET fabrics’, Surf. Eng., 2011, 27, (1), 5–10.
   Web of Science ®Google Scholar
• A. Agarwal, M. Pujari, R. Uppaluri and A. Verma: ‘Rate enhanced electroless fabrication of nickel ceramic composite membranes’, Surf. Eng., 2015, 31, (3), 221–225.
   Web of Science ®Google Scholar
• M. Franco, W. Sha, G. Aldic, S. Malinov and H. Çimenoğlu: ‘Effect of reinforcement and heat treatment on elevated temperature sliding of electroless Ni-P/SiC composite coatings’, Tribol. Int., 2016, 97, 265–271.
   Web of Science ®Google Scholar
• S. H. Hashemi and R. Shoja-Razavi: ‘Laser surface heat treatment of electroless Ni-P-SiC coating on Al356 alloy’, Opt. Laser. Technol., 2016, 85, 1–6.
   Web of Science ®Google Scholar
• J. Hu, L. Fang and P. W. Zhong: ‘Effect of reinforcement particle size on fabrication and properties of composite coatings’, Mater. Manuf. Process, 2013, 28, (12), 1294–1300.
   Web of Science ®Google Scholar
• K. Theeratatpong, S. Danchaivijit and Y. Boonyongmaneerat: ‘Effects of Co content and heat treatment on mechanical properties of electrolessly deposited Ni-Co-P alloys’, Surf. Interface Anal., 2014, 46, 276–282.
   Web of Science ®Google Scholar
• A. E. Fetohi, R. M. Abdel Hameed, K. M. El-Khatib and Eglal R. Souaya: ‘Ni-P and Ni-Co-P coated aluminum alloy 5251 substrates as metallic bipolar plates for PEM fuel cell applications’, Int. J. Hydrogenenerg., 2012, 37, (9), 7677–7688.
   Web of Science ®Google Scholar
• U. Matik: ‘Structural and wear properties of heat-treated electroless Ni-P alloy and Ni-P-Si3N4 composite coatings on iron based PM compacts’, Surf. Coat. Technol., 2016, 302, 528–534.
   Web of Science ®Google Scholar
• M. Stern and A. L. Geary: ‘Electrochemical polarization’, J. Electrochem. Soc., 1957, 104, 56–63.
   Web of Science ®Google Scholar
• S. Ranganatha, T. V. Venkatesha and K. Vathsala: ‘Process and properties of electroless Ni-Cu-P-ZrO2 nanocomposite coatings’, Mater. Res. Bull., 2012, 47, 635–645.
   Web of Science ®Google Scholar
• P. Gyftou, M. Stroumbouli, E. A. Pavlatou, P. Asimidis and N. Spyrellis: ‘Tribological study of Ni matrix composite coatings containing nano and micro SiC particles’, Electrochim. Acta, 2005, 50, 4544–4550.
   Web of Science ®Google Scholar
• L. Shi, C. F. Sun, P. Gao, F. Zhou and W. M. Liu: ‘Mechanical properties and wear and corrosion resistance of electrodeposited Ni-Co/SiC nanocomposite coating’, Appl. Surf. Sci., 2006, 252, (10), 3591–3599.
   Web of Science ®Google Scholar
• I. R. Mafi and C. Dehghanian: ‘Studying the effects of the addition of TiN nanoparticles to Ni-P electroless coatings’, Appl. Surf. Sci., 2011, 258, (5), 1876–1880.
   Web of Science ®Google Scholar
• K. Krishnaveni, T. S. N. Sankara Narayanan and S. K. Seshadri: ‘Corrosion resistance of electrodeposited Ni-B and Ni-B-Si3N4 composite coatings’, J. Alloys Compd., 2009, 480, 765–770.
   Web of Science ®Google Scholar