Numerical Simulation for Injection Molding with a Rapidly Heated Mold, Part II: Birefringence Prediction

REFERENCES

• Johnson , L.I. Strain-free injection molding . Mod. Plast. 1963 , 40 , 111 – 117 .
   Google Scholar
• Kim , B. ; Roth , C. Critical J-integral value of molded polycarbonate using a low thermal injection mold . Polym.-Plast. Technol. 1988 , 27 , 467 – 485 .
   Web of Science ®Google Scholar
• Jansen , K.M.B. ; Flaman , A.A.M. The influence of surface heating on the birefringence distribution in injection molded part . Polym. Eng. Sci. 1994 , 34 , 898 – 904 .
   Web of Science ®Google Scholar
• Chen , M. ; Yao , D. ; Kim , B. Eliminating flow induced birefringence and minimizing thermally induced residual stresses in injection molded parts . Polym.-Plast. Technol. 2001 , 40 , 491 – 503 .
   Web of Science ®Google Scholar
• Isayev , A.I. ; Hieber , C.A. Toward a viscoelastic modeling of the injection molding of polymers . Rheol. Acta. 1980 , 19 , 168 – 182 .
   Web of Science ®Google Scholar
• Flaman , A.A.M. Buildup and relaxation of molecular orientation in injection molding. Part I: Formulation . Polym. Eng. Sci. 1993 , 33 , 193 – 201 .
   Web of Science ®Google Scholar
• Flaman , A.A.M. Buildup and relaxation of molecular orientation in injection molding. Part II: Experimental verification . Polym. Eng. Sci. 1993 , 33 , 202 – 210 .
   Web of Science ®Google Scholar
• Lee , Y.B. ; Kwon , T.H. ; Yoon , K.H. Numerical prediction of residual stresses and birefringence in injection/compression molded center-gated disk. Part I: Basic modeling and results for injection molding . Polym. Eng. Sci. 2002 , 42 , 2246 – 2272 .
   Web of Science ®Google Scholar
• Lee , Y.B. ; Kwon , T.H. ; Yoon , K.H. Numerical prediction of residual stresses and birefringence in injection/compression molded center-gated disk. Part II: Effects of processing conditions . Polym. Eng. Sci. 2002 , 42 , 2273 – 2292 .
   Web of Science ®Google Scholar
• Park , K. A study on flow simulation and deformation analysis for injection-molded plastic parts using three-dimensional solid elements . Polym.-Plast. Technol. 2004 , 43 , 1569 – 1585 .
   Web of Science ®Google Scholar
• Toray Industries Inc. 3D TIMON® 7.0—Reference Manual 2002 .
   Google Scholar
• Chen , M. Residual stress and birefringence in injection molding . M.S. Thesis, University of Massachusetts, Amherst , 2000 .
   Google Scholar