REFERENCES
- Liu , S.-J. Effects of processing parameters on formation of sink marks on injection molded pars . Plast. Rubber Compos. 2001 , 30 ( 4 ), 170 – 174 .
- Beiter , K. ; Ishii , L. ; Hornberger , L. Geometry-based index for predicting sink mark in plastic parts . Am. Soc. Mech. Eng. 1991 , 31 , 111 – 118 .
- Väätäinen,O.; Järvel , P. ; Valta , K. The effect of processing parameters on the quality of injection moulded parts by using the taguchi parameter design method . Plast. Rubber Compos. 1994 , 21 ( 4 ), 211 – 217 .
- Ye , H. ; Phillip , M. ; Leopold . Minimizing part sink marks using C-Mold and genetic-optimization algorithm . Annual Technical Conference—Antec'99, Society of Plastics Engineers : New york 1999 , 589 – 593 .
- Liu , S.-J. ; Lin , C.H. ; Wu , Y.C. Minimizing the sink marks in injection molded thermoplastics . Adv. Polym. Technol. 2001 , 20 ( 3 ), 202 – 215 .
- Park , K.J. ; Ahn , H. Design of experiment considering two-way interactions and its application to injection molding processes with numerical analysis . J. Mater. Process. Tech. 2004 , 146 , 221 – 227 .
- Liu , S.-J. ; Wu , J.Y. ; Chang , J.H. ; Hung , S.W. An experimental matrix design to optimize the weldline strength in injection molded parts . Polym. Eng. Sci. 2000 , 40 ( 5 ), 1256 – 1262 .
- Ozcelik , B. ; Erzurumlu , T. Comparison of the warpage optimization in the plastic injection molding using AVOVA, neural network model and genetic algorithm . J. Mater. Process. Tech. 2006 , 171 , 437 – 445 .
- Tseng , W.J. ; Chiang , D. Influence of molding variables on defect formation and mechanical strength of injection-molded caramics . J. Mater. Process. Tech. 1998 , 84 , 225 – 235 .
- Huang , M.C. ; Tai , C.C. The effective factors in the warpage problem of an injection-molded part with a thin shell feature . J. Mater. Process. Tech. 2001 , 110 , 1 – 9 .