References
- Akiije, I. and Moyinwin, V.A., 2013. Laboratory assessment of highways asphalt bitumen in southwest of Nigeria. Journal of Emerging Trends in Engineering and Applied Sciences, 4 (2), 2013.
- Asphalt Institute, 1995. Mix design methods for asphalt concrete and other hot-mix types MS-2. 6th ed. Lexington, KY: The Asphalt Institute.
- Brown, E.R., Cross, S. A., and Gehler, J.G., 1991. Evaluation of pavement bleeding problem on I-55 in Illinois. Auburn: National Center for Asphalt Technology.
- Brown, E.R. and Heitzman, M., 2013. Thin HMA overlays for pavement preservation and low volume asphalt roads National Centre for Asphalt Technology. Auburn: NCAT (National Centre for Asphalt Technology), Report No. 13-05.
- Emery, S.J. and Coret, S.C.A., 1994. Current practice for the construction of hot asphalt surfacings by hand. Johannesburg: University of the Witwatersrand.
- Hafeez, I. and Kamal, M.A., 2009. Impact of hot mix asphalt properties on its permanent deformation behaviour. Taxila: PhD Civil Engineering, Faculty of Civil & Environmental Engineering, University of Engineering and Technology.
- Hrdlicka, G.M., et al., 2007. Evaluation of binder tests for identifying rutting and cracking potential of modified asphalt binders. Washington, DC: Transportation Research Board, Report No. 0-4824-1.
- Kandhal, P.S. and Cross, S.A., 1993. Effect of aggregate gradation on measured asphalt content. Auburn: National Center for Asphalt Technology.
- Nejad, F.M., Aflaki, E., and Mohammadi, M.A., 2010. Fatigue behavior of SMA and HMA mixtures. Construction and Building Materials, 24 (7), 1158–1165.10.1016/j.conbuildmat.2009.12.025
- SABITA, 2008. Guidelines for the manufacture and construction of hot mix asphalt. South Africa: SABITA.
- SATTC, 2003. SATTC guidelines for low volume roads. Gaborone: SADC.
- Srivastava, A. and Roijen, R.V., 2000. Bitumen performance in hot and arid climates. A paper prepared for pavement seminar for the Middle East and North Africa region on innovative road rehabilitation and recycling technologies: New policies and practices in pavement design and education, Amman, Jordan.
- Stroup-Gardiner, M., et al., 2000. Segregation in hot-mix asphalt pavements. Washington, DC: National Academy Press.
- Sultana, S. and Bhasin, A., 2014. Effect of chemical composition on rheology and mechanical properties of asphalt binder. Construction and Building Materials, 72, 293–300.10.1016/j.conbuildmat.2014.09.022
- Taute, A., et al., 2007. Hot mix asphalt control. In: Proceedings of the 9th conference on asphalt pavements for Southern Africa, Gaborone, Botswana.
- Thagesen, B., 1996. Highway and traffic engineering in developing countries. London: E & FN Spon.10.4324/9780203223673
- Transportation Research Board, 2011. A manual for design of hot mix asphalt with commentary. LLC Sterling, VA: Advanced Asphalt Technologies.
- Transport Research Laboratory, 1993. Road Note 31.
- US Army Corps of Engineers, 2000. Project organization, mix design, and quality control. In: In hot-mix asphalt paving handbook. US: US Army Corps of Engineers, 7–8.
- West, E., 2005. A guideline for the design and construction of asphalt pavements for Colorado trails and paths. Colorado: Colorado Asphalt Pavement Association.