References
- Z. Zhenye, Interview of academician Zhao Zhen-ye. Aero Eng. 35 (3), 1 (2009).
- Z. Huiping, W. Cong xun, and D. Xu, Aircraft landing gear with the development of 300M ultra high strength steel and research. J. Harbin Univ. Sci. Technol. 16 (6), 73 (2011).
- Z. Huiping et al., Surface roughness and residual stresses of high speed turning 300M ultrahigh strength steel. Adv. Mech. Eng. 6 (2014), 859207 (2014). VolDOI: 10.1155/2014/859207.
- B. Zhang et al., Experimental research on tool wear in milling 300M with coated tool. Aviation Precis. Manuf. Technol. 44 (2), 41 (2008).
- W. R. Maruda, S. Legutko, and G. Krolczyk, Effect of minimum quantity cooling lubrication (MQCL) on chip morphology and surface roughness in turning low carbon steels. AMM. 657, 38 (2014). DOI: 10.4028/www.scientific.net/AMM.657.38.
- S. M. Yuan et al., Effects of cooling air temperature on cryogenic machining of Ti-6Al-4V alloy. J. Mater. Process. Technol. 211 (3), 356 (2011). DOI: 10.1016/j.jmatprotec.2010.10.009.
- M. C. S. Alves, E. C. Bianchi, and P. R. Aguiar, Influence of optimized lubrication-cooling and minimum quantity lubrication on the cutting forces on the geometric quality of the surfaces and on the micro-structural integrity of hardened steel parts. Matéria 16 (3), 754 (2011). DOI: 10.1590/S1517-70762011000300003.
- Z. Liu, M. Chen, and Q. An, Investigation of friction in end-milling of Ti-6Al-4V under different green cutting conditions. Int. J. Adv. Manuf. Technol. 8 (5–8), 1181 (2015). DOI: 10.1007/s00170-014-6730-6.
- A. Attanasio, M. Gelfi, C. Giardini, et al., Minimal quantity lubrication in turning: Effect on tool wear. WEAR 260 (3), 333 (2006). DOI: 10.1016/j.wear.2005.04.024.
- A. Shokrani, V. Dhokia, and S. T. Newman, Environmentally conscious machining of difficult-to-machine materials with regard to cutting fluids. Int. J. Mach. Tools Manuf. 57, 83 (2012). DOI: 10.1016/j.ijmachtools.2012.02.002.
- J. H. Holland, Adaption in Nature and Artificial Systems (MIT Press, Cambridge, MA, 1992).