References
- Bertoldi, D.A. et al. (1994) “An experimental study of protection alternatives at bridge piers,” Federal Highway Admin., Turner-Fairbank Laboratory, Virginia.
- Blodgett, J.C. and McConaughy, C.E. (1985) “Evaluation of rock riprap design practices for protection of channels near highway structures – Phase I,” Preliminary Report subject to revision, prepared by the U.S. Geological Survey in cooperation with Federal Highway Administration.
- Chiew, Y.M. (1984) “Local scour at bridge piers,” Report No. 355, School of Engineering, The University of Auckland, Auckland, New Zealand, 200pp.
- Chiew, Y.M. (1995) “Mechanics of riprap failure at bridge piers,” Journal of Hydraulic Engineering, A. S.C.E., 121(9), 635–643.
- Coleman, S.E., Lauchlan, C.S. and Melville, B. W. “Clear-water scour development at bridge abutments,” Journal of Hydraulic Research, IAHR, 41(5), 521–532.
- Dongol, D. M. S. (1994). “Local scour at bridge abutments.” Report No. 544, School of Engineering, The University of Auckland, Auckland, New Zealand, 409pp.
- Ettema, R. (1980) “Scour at bridge piers,” Report No. 216, School of Engineering, The University of Auckland, Auckland, New Zealand, 527pp.
- Eve, N.J. (1999), “Riprap protection of bridge abutments”, M.E. Thesis, Civil and Resource Engineering Department, The University of Auckland, Auckland, New Zealand.
- Hoe, D.A. (2001) “Cable-tied block protection of bridge abutments,” Project Report No. PCRE 01:18, Department of Civil and Resource Engineering, The University of Auckland, Auckland, New Zealand, 75pp.
- Garde, R.J. (1961) “Local bed variation at bridge piers in alluvial channels,” Univertsity of Roorkee Research Journal, Vol. IV, No. 1, 101–116.
- Gill, M.A. (1972) “Erosion of sand beds around spur dikes,” Journal of the Hydraulics Division, A.S.C.E., 98(9), 1587–1602.
- Jones, J.S., Bertoldi, D.A. and Stein, S. (1995) “Alternative scour countermeasures,” Proc., Hydraulic Engineering ’95, San Antonio, Texas, U.S.A.
- Kandasamy, J.K. (1989) “Abutment scour,” Report No. 458, School of Engineering, The University of Auckland, Auckland, New Zealand, 278pp.
- Kwan, T. F. (1984). “Study of abutment scour.” Report No. 328, School of Engineering, The University of Auckland, Auckland, New Zealand, 225pp.
- Kwan, T.F. (1988) “A study of abutment scour,” Report No. 451, School of Engineering, The University of Auckland, Auckland, New Zealand, 461pp.
- Lauchlan, C.S. (1999) “Countermeasures for pier scour,” PhD thesis, The University of Auckland, Auckland, New Zealand.
- Laursen, E.M. (1960) “Scour at bridge crossings,” Journal of the Hydraulics Division, A.S.C.E., 86(2), 39–54.
- McCorquodale, J.A. et al. (1993) “Guide for Design and Placement of Cable-Tied Block Erosion Protection,” Proceedings Hydraulic Engineering, San Francisco, 1357–1362.
- Melville, B. W., and Coleman, S. E. (2000). Bridge scour. Water Resources Publications, LLC, Colorado, U.S.A. 550pp.
- Parker, G., Toro-Escobar, C. and Voigt, R.L., Jr. (1998) “Countermeasures to protect bridge piers from scour,” Draft Final Report (Project NCHRP 24–7) prepared for National Co-operative Highway Research Program, University of Minnesota, Minneapolis, Minnesota, U.S.A., 402pp.
- Parola, A.C. (1993) “Stability of riprap at bridge piers,” Journal of Hydraulic Engineering, A.S.C.E., 119(10), 1080–1093.
- Przedwojski, B., Blazejeski, R. and Pilarczyk, K.W. (1995) River Training Techniques, A.A. Balkema, Rotterdam, Netherlands.
- Tey, C. B. (1984). “Local scour at bridge abutments.” Report No. 329, School of Engineering, The University of Auckland, Auckland, New Zealand, 111pp.
- Wong, W.H. (1982) “Scour at bridge abutments,” Report No. 275, School of Engineering, The University of Auckland, Auckland, New Zealand, 109pp.