Structure-property correlation of eutectic Al-12.4 Si alloys with and without Zirconium (Zr) addition

References

• Biswas P, Mondal MK, Mandal D. Effect of Mg2Si Concentration on the Dry Sliding Wear Behavior of Al–Mg2Si Composite. J Tribol-T ASME. 2019;141(8):081601.
   Web of Science ®Google Scholar
• Robles-Hernandez FC, Ramírez JMH, Mackay R. Al-Si alloys: automotive, aeronautical, and aerospace applications. 1st ed. Springer International Publishing AG; 2017. p. 1–6.
   Google Scholar
• Vijayan V, Prabhu KN. The effect of simultaneous refinement and modification by cerium on microstructure and mechanical properties of Al-8% Si alloy. Int J Cast Met Res. 2016;29(6):345–349.
   Web of Science ®Google Scholar
• Biswas P, Patra S, Mondal MK. Effects of Mn addition on microstructure and hardness of Al-12.6Si alloy. IOP Conf Series Mater Sci Eng. 2018;338:1–6.
   Google Scholar
• Vijayan V, Prabhu KN. The effect of Sr modification on thermal diffusivity of Al–8Si alloy. Int J Cast Met Res. 2018;31(2):80–86.
   Web of Science ®Google Scholar
• Nan K, Pierre C, Chaoyue C, et al. Mater Des. 2016;99:120–126.
   Web of Science ®Google Scholar
• Li Q, Xia T, Lan Y, et al. Effect of rare earth cerium addition on the microstructure and tensile properties of hypereutectic Al–20%Si alloy. J Alloys Compd. 2013;562:25–32.
   Web of Science ®Google Scholar
• Voigt RC, Bye DR. AFS Trans. 1991;99:33–50.
   Google Scholar
• Cai Z, Zhang C, Wang R, et al. Preparation of Al–Si alloys by a rapid solidification and powder metallurgy route. Mater Des. 2015;87:996–1002.
   Web of Science ®Google Scholar
• Menargues S, Martín E, Baile MT, et al. New short T6 heat treatments for aluminium silicon alloys obtained by semisolid forming. Mater Sci Eng A. 2015;621:236–242.
   Web of Science ®Google Scholar
• Ban B, Li Y, Zuo Q, et al. Refining of metallurgical grade Si by solidification of Al–Si melt under electromagnetic stirring. J Mater Process Technol. 2015;222:142–147.
   Web of Science ®Google Scholar
• Saigal A, Fuller ER. Analysis of stresses in aluminum–silicon alloys. Comput Mater Sci. 2001;21(1):149–158.
   Web of Science ®Google Scholar
• Birol Y. Effect of silicon content in grain refining hypoeutectic Al–Si foundry alloys with boron and titanium additions. Mater Sci Technol. 2012;28(4):385–389.
   Web of Science ®Google Scholar
• Auradi V, Kori SA. Effect Of Processing Temperature On The Microstructure Of Al-7Ti Master Alloy And On Refinement Of Alpha-Al Dendrites In Al-7Si Alloys. Adv Mater Lett. 2015;6(3):252–259.
   Google Scholar
• Chen JX, Lu MJ, Wu SS, et al. Study on Eutectic Microstructure and Modification Mechanism of Al-Si Alloys. Mater Sci Forum. 2017;877:97–103.
   Google Scholar
• Fakhraei O, Emamy M, Farhangi H. The effect of Al–5Ti–1B grain refiner on the structure and tensile properties of Al–20%Mg alloy. Mater Sci Eng A. 2013;560:148–153.
   Web of Science ®Google Scholar
• Chen Y, Pan Y, Lu T, et al. Effects of combinative addition of lanthanum and boron on grain refinement of Al–Si casting alloys. Mater Des. 2014;64:423–426.
   Web of Science ®Google Scholar
• Gruzleski JE, Closset BM. The treatment of liquid aluminium-silicon alloys. 1st ed. Des Plaines, USA: American Foundrymen’s Society; 1990. p. 34.
   Google Scholar
• Srirangam P, Kramer MJ, Shankar S. Effect of strontium on liquid structure of Al–Si hypoeutectic alloys using high-energy X-ray diffraction. Acta Mater. 2011;59(2):503–513.
   Web of Science ®Google Scholar
• Tahiri H, Mohamed SS, Doty HW, et al. Effect of Sr–Grain Refining–Si Interactions on the Microstructural Characteristics of Al–Si Hypoeutectic Alloys. Int J Metalcast. 2018;12(2):343–361.
   Web of Science ®Google Scholar
• Weixi S, Bo G, Ganfeng T, et al. J Rare Earth. 2010;28:367–370.
   Web of Science ®Google Scholar
• Hu Z, Ruan XM, Yan H. Effects of neodymium addition on microstructure and mechanical properties of near-eutectic Al–12Si alloys. Trans Nonferr Met Soc China. 2015;25: 3877–3885.
   Google Scholar
• Li Q, Xia T, Lan Y, et al. Effects of rare earth Er addition on microstructure and mechanical properties of hypereutectic Al–20% Si alloy. Mater Sci Eng A. 2013;588:97–102.
   Web of Science ®Google Scholar
• Zhan JC, Ding DY, Zhan WL, et al. Effect of Zr addition on microstructure and properties of Al–Mn–Si–Zn-based alloy. Trans Nonferr Met Soc China. 2014;24: 3872–3878.
   Google Scholar
• Qian H, Zhu D, Hu C, et al. Effects of Zr Additive on Microstructure, Mechanical Properties, and Fractography of Al-Si Alloy. Metals. 2018;8(2):124–133.
   Web of Science ®Google Scholar
• Mondal MK, Biswas K, Maity J. Microstructural characterisation of novel 6351 Al–Al 4 SiC4 in-situ composite. Mater Sci Technol. 2013;29(11):1394–1402.
   Web of Science ®Google Scholar
• Haghshenas M, Jamali J. Assessment of circumferential cracks in hypereutectic Al-Si clutch housings. Case Stud Eng Fail Anal. 2017;8:11–20.
   Google Scholar
• Sepehrband P, Mahmudi R, Khomamizadeh F. Effect of Zr addition on the aging behavior of A319 aluminum cast alloy. Scr Mater. 2005;52(4):253–257.
   Web of Science ®Google Scholar
• Robson JD, Prangnell PB. Acta Metall. 2001;49:599–613.
   Google Scholar
• Meng Y, Cui J, Zhao Z, et al. Effect of Zr on microstructures and mechanical properties of an AlMgSiCuCr alloy prepared by low frequency electromagnetic casting. Mater Charact. 2014;92:138–148.
   Web of Science ®Google Scholar
• Yongdong H, Xinming Z, Zhiqiang C. Effect of Minor Cr, Mn, Zr, Ti and B on Grain Refinement of As-Cast Al-Zn-Mg-Cu Alloys. Rare Met Mater Eng. 2010;39(7):1135–1140.
   Web of Science ®Google Scholar
• Dang JZ, Huang YF, Cheng J. Effect of Sc and Zr on microstructures and mechanical properties of as-cast Al-Mg-Si-Mn alloys. Trans Nonferr Met Soc China. 2009;19: 540–544.
   Web of Science ®Google Scholar
• Qin QD, Zhao YG, Liu C, et al. Strontium modification and formation of cubic primary Mg2Si crystals in Mg2Si/Al composite. J Alloys Compd. 2007;454:142–146.
   Web of Science ®Google Scholar
• Hu Z, Dong Z, Yin Z, et al. Solidification behavior, microstructure and silicon twinning of Al-10Si alloys with ytterbium addition. J Rare Earth. 2018;36(6):662–668.
   Web of Science ®Google Scholar
• Goswami R, Spanos G, Paoa PS, et al. Precipitation behavior of the ß phase in Al-5083. Mater Sci Eng A. 2010;527(4–5):1089–1095.
   Web of Science ®Google Scholar
• Biswas P, Mondal MK, Roy H, et al. Microstructural evolution and hardness property of in situ Al–Mg 2 Si composites using one-step gravity casting method. Can Metall Q. 2017;56(3):340–348.
   Web of Science ®Google Scholar
• Yu HC, Wang HY, Chen L, et al. Spheroidization of primary Mg2Si in Al-20Mg2Si-4.5Cu alloy modified with Ca and Sb during T6 heat treatment process. Mater Sci Eng A. 2017;685:31–38.
   Web of Science ®Google Scholar
• Kucukomeroglu T. Effect of equal-channel angular extrusion on mechanical and wear properties of eutectic Al–12Si alloy. Mater Des. 2010;31(2):782–789.
   Web of Science ®Google Scholar
• Fang L, Fuxiao Y, Dazhi Z, et al. Effect of Zr, Cr and Pr additions on microstructures and properties of ultra-high strength Al–Zn–Mg–Cu alloys. Mater Sci Eng A. 2011;528:3786–3790.
   Web of Science ®Google Scholar
• Haro-Rodríguez S, Goytia-Reyes R, Dwivedi DK, et al. On influence of Ti and Sr on microstructure, mechanical properties and quality index of cast eutectic Al–Si–Mg alloy. Mater Des. 2011;32(4):1865–1871.
   Web of Science ®Google Scholar
• Wang Y, Liao H, Wu Y, et al. Effect of Si content on microstructure and mechanical properties of Al–Si–Mg alloys. Mater Des. 2014;53:634–638.
   Web of Science ®Google Scholar
• Gupta M, Ling S. Microstructure and mechanical properties of hypo/hyper-eutectic Al–Si alloys synthesized using a near-net shape forming technique. J Alloys Compd. 1999;287(1–2):284–294.
   Web of Science ®Google Scholar
• Farahany S, Ourdjini A, Abu Bakar TA, et al. Role of bismuth on solidification, microstructure and mechanical properties of a near eutectic Al-Si alloys. Met Mater Int. 2014;20:929–938.
   Web of Science ®Google Scholar
• Wang ER, Hui XD, Wang SS, et al. Improved mechanical properties in cast Al–Si alloys by combined alloying of Fe and Cu. Mater Sci Eng A. 2010;527:7878–7884.
   Web of Science ®Google Scholar
• Biswas P, Biswas A, Bhandari R, et al. Microstructure, mechanical properties and fracture behavior of in-situ Al-5Mg-Al4Sr composites. Mater Today Comm. 2018;15: 190–198.
   Web of Science ®Google Scholar