References
- M. Neville and J. J. Brooks: ‘ConcreteTechnology’, 438; 1994, England, Longman.
- A. V. Levy: ‘Solid particle erosion and erosion–corrosion of materials’; 1995, Materials Park, OH: ASM International.
- Y. Zhou, Z. Lu and M. Zhan ‘An investigation of the erosion–corrosion characteristics of ductile cast iron’, Mater. Des., 2007, 28, 260–265. doi: 10.1016/j.matdes.2005.07.011
- H. W. Wang and M. M. Stack: ‘The erosive wear of mild and stainless steels under controlled corrosion in alkaline slurries containing alumina particles’, J. Mater. Sci., 2000, 35, 5263–5273. doi: 10.1023/A:1004865107688
- J. O. Bello, R. J. K. Wood and J. A. Wharton: ‘Synergistic effects of micro-abrasion–corrosion of UNS S30403, S31603 and S32760 stainless steels’, Wear, 2007, 263, 149–159. doi: 10.1016/j.wear.2006.12.044
- M. M. Stack, N. Corlett and S. Turgoose: ‘Some thoughts on modelling the effects of oxygen and particle concentration on the erosion–corrosion of steels in aqueous slurries’, Wear, 2003, 255, 225–236. doi: 10.1016/S0043-1648(03)00205-9
- Y. G. Zheng, Z. M. Yao and W. Ke: ‘Erosion–corrosion resistant alloy development for aggressive slurry flows’, Mater. Lett., 2000, 46, 362–368. doi: 10.1016/S0167-577X(00)00255-X
- F. Aiming, L. Jinming and T. Ziyun: ‘An investigation of the corrosive wear of stainless steels in aqueous slurries’, Wear, 1996, 193, 73–77. doi: 10.1016/0043-1648(95)06684-5
- Y. Zhang, M. Collepardi, L. Coppola, W. L. Guan and P. Zaffaroni: ‘Optimization of the high-strength superplasticized concrete of the three-Gorge dam in China’, Industria Italiana del Cemento, 2003, 73, 58–69.
- C. Andrade and J. A. González: ‘Quantitative measurements of corrosion rate of reinforcing steels embedded in concrete using polarization resistance measurements’, Werkstoffe und Korrosion, 1978, 29, 515–519. doi: 10.1002/maco.19780290804
- T. Pastore and P. Pedeferri: ‘Corrosion behavior of duplex stainless steel in chloride contaminated concrete’, Proc. Int. Conf. on 'Stainless Steel', Vol. 1, ISIJ, Chiba, 1991, 351–358.
- V. Y. Filinovsky and Y. V. Pleskov: ‘Rotating sik and ring-disk electrodes’, in ‘Comprehensive treatise of electrochemistry’, (eds. E. Yeager, J. O’M. Bockris, B. E. Conway and S. Sarangapani), Vol. 9, 293; 1985, New York, Plenum Press.
- M. Eisenberg, C. W. Tobias and R. Wilkie: ‘Ionic mass transfer and concentration polarization at rotating electrodes', J. Electrochem. Soc., 1954, 101, 306.
- D. C. Silverman: ‘The rotating cylinder electrode for examining velocity-sensitive corrosion—a review’, Corrosion, 2004, 60, (11), 1003–1023. doi: 10.5006/1.3299215
- V. G. Levich: ‘Physical hydrodynamics’, 71; 1962, Englewood Cliffs, NJ, Prentice-Hall.
- A. A. Rashaida: ‘Flow of a non-Newtonian Bingham plastic fluid over a rotating disk’, Doctoral thesis, University of Saskatchewan, 2005.
- B.T. Lu, J. L. Luo, F. Mohammadi, K. Wang and X. M. Wan: ‘Correlation between repassivation kinetics and corrosion rate over a passive surface in flowing slurry’, Electrochem. Acta, 2008, 53, 7022–7031. doi: 10.1016/j.electacta.2008.02.083
- M. Cabrini, M. Cortellini, S. Lorenzi, P. Marcassoli and T. Pastore: ‘Erosion and corrosion of steel in fresh concrete’, Metall. Ital., 2010, 102, (5), 39–44.
- S. Lorenzi: ‘Corrosione-erosione dell'acciaio a contatto con conglomerati cementizi allo stato fresco’, Doctoral dissertation, Bergamo, Italy, 2010.