References
- Z. Ye and K. Pang, et al., “Simulation analysis of the tensile mechanical properties of a hydraulic strain clamp-conductor system,” Adv. Mater. Sci. Eng., vol. 2020, p. 4591812, 2020. DOI: 10.1155/2020/4591812.
- I. Makhkamova, K. Mahkamov and P. Taylor, “CFD thermal modelling of lynx overhead conductors in distribution networks with integrated renewable energy driven generators,” Appl. Therm. Eng., vol. 58, pp. 522–535, 2013. DOI: 10.1016/j.applthermaleng.2013.04.066.
- T. Zhang and W. Zheng, et al., “A case study of rupture in 110 kV overhead conductor repaired by full-tension splice,” Eng. Failure Anal., vol. 108, p. 104349, 2020. DOI: 10.1016/j.engfailanal.2019.104349.
- S. Lalonde, R. Guilbault and S. Langlois, “Numerical analysis of ACSR conductor-clamp systems undergoing wind-induced cyclic loads,” IEEE Trans. Power Deliv., vol. 33, no. 4, pp. 1–9, 2018. DOI: 10.1109/TPWRD.2017.2704934.
- IEC-61284 Standard. “Overhead lines: requirements and tests for fittings,” 1997.
- M. Hrabcik and R. Gono, “Issues of Dead-End Clamps,” In Proceeding of the 12th International Scientific Conference of Electric Power Engineering, Technical University of Ostrava, 2011.
- N. M. Zainuddin and M. S. A. Rahman, et al., “Review of thermal stress and condition monitoring technologies for overhead transmission lines: issues and challenges,” IEEE Access, vol. 8, pp. 120053–120081, 2020.
- C. Bernauer and H. Böhme, et al., “Temperature measurement on overhead transmission lines (OHTL) utilizing surface acoustic wave (SAW) sensors", 19th Int. Conf. Electr. Distrib. CIRED, pp. 21–24, 2007.
- E. Golinelli and S. Musazzi, et al., “Laser based scanning system for high voltage power lines conductors monitoring,” IET Conf., Prague, Czech Republic, pp. 484–487, 2009.
- T. K. Gangopadhyay, M. C. Paul and L. Bjerkan, “Fiber-optic sensor for real-time monitoring of temperature on high voltage (400 KV) power transmission lines", 20th Int. Conf. Opt. Fiber Sensors, pp. 1–4, 2009.
- J. Dadashizadeh Samakosh and M. Mirzaie, “Analysis of leakage current characteristics during aging process of SiR insulator under uniform and longitudinal non-uniform pollution conditions,” Measurement, vol. 147, p. 106862, 2019. DOI: 10.1016/j.measurement.2019.106862.
- M. Hrabcik and R. Gono, “Analysis of issues in long-term thermovision measurements in distribution networks,” In Proceeding of the 11th International Scientific Conference of Electric Power Engineering, Technical University of Ostrava, pp. 721–725, 2010.
- NETA. “IR scanning handbook,” 2009.
- P. R. Muniz, S. P. N. Cani and R. D. S. Magalhaes, “Influence of field of view of thermal imagers and angle of view on temperature measurements by infrared thermovision,” IEEE Sensors J., vol. 14, no. 3, pp. 729–733, 2014. DOI: 10.1109/JSEN.2013.2287003.