References
- Boehm, W. (1980) Inserting new knots into B-spline curves. Computer Aided Design, 12(4), 199–201.
- Boehm, W. (1981) Generating the Bezier points of B-spline curves and surfaces. Computer Aided Design, 13(6), 365–366.
- Choi, B. (1991) Surface Modeling for CAD/CAM, Elsevier, Amsterdam.
- Farin, G. (1990) Curves and Surfaces for Computer Aided Geometric Design, Academic Press, San Diego.
- Joshi, S. and Chang, T.C. (1986) Feasible tool approach directions for machining holes in automated process planning systems, in Proc. ASME Symposium on Integrated and Intelligent Manufacturing, Anaheim, CA, USA.
- Kim, D. (1990) Cones on Bezier curves and surfaces. Ph.D. dissertation, Department of Industrial and Operations Engineering, University of Michigan, USA.
- Kim, K. and Ko, B. (1994) Generating NC tool paths for sculptured surface manufacture. Computers and Industrial Engineering, 26(2), 359–368.
- Peng, Q.S. (1984) An algorithm for finding the intersection lines between two B-spline surfaces. Computer Aided Design, 16(4), 191–196.
- Schmitt, F.J.M., Barsky, B.A. and Du, W. (1986) An adaptive subdivision method for surface fitting from sampled data. Computer Graphics, 20(4), 179–188.
- Su, C. and Mukerjee, A. (1991) Automated machinability checking for CAD/CAM. IEEE Trans. on Robotics and Automation, 7(5), 691–699
- Tseng, Y. and Joshi, S. (1991) Determining feasible tool approach directions for machining Bezier curves and surfaces. Computer Aided Design, 23(5), 367–379.