Investigation on Flow Through Staggered Micro Pin Fin Arrays with Variable Longitudinal Spacings Using Micro-PIV

References

• S. G. Kandlikar and W. J. Grande, “Evaluation of single phase flow in micro channels for high heat flux chip cooling-Thermo hydraulic performance enhancement and fabrication technology,” Heat Transfer. Eng, vol. 25, pp. 5–16, 2004. DOI:10.1080/01457630490519772.
   Google Scholar
• Y. Y. Wang, J. H. Shin, C. Woodcock, X. Yu, and Y. Peles, “Experimental and numerical study about local heat transfer in a microchannel with a pin fin,” Int. J. Heat Mass Tran, vol. 121, no, 534–546, 2018.01.034, 2018, doi:10.1016/j.ijheatmasstransfer.
   Google Scholar
• C. Woodcock, et al., “Ultra-high heat flux dissipation with Piranha Pin Fins,” Int. J. Heat Mass Transf, vol. 128, pp. 504–515, 2019. DOI:10.1016/j.ijheatmasstransfer.2018.09.030.
   Google Scholar
• X. Zhou, B. Dong, C. Chen, and W. Z. Li, “A thermal LBM-LES model in body-fitted coordinates: flow and heat transfer around a circular cylinder in a wide Reynolds number range,” Int. J. Heat Fluid Fl, vol. 77, pp. 113–121, 2019. DOI:10.1016/j.ijheatfluidflow.2019.04.001.
   Google Scholar
• T. Yeom, et al., “Enhanced heat transfer of heat sink channels with micro pin fin roughened walls,” Int. J. Heat Mass Transf, vol. 92, pp. 617–627, 2016. DOI:10.1016/j.ijheatmasstransfer.2015.09.014.
   Google Scholar
• A. Mohammadi and A. Kosar, “Review on heat and fluid flow in micro pin fin heat sinks under single-phase and two-phase flow conditions,” Nanosc. Microsc. Therm, vol. 22, pp. 153–197, 2018. DOI:10.1080/15567265.2018.1475525.
   Google Scholar
• D. Lorenzini, et al., “Embedded single phase microfluidic thermal management for nonuniform heating and hotspots using microgaps with variable pin fin clustering,” Int. J. Heat Mass Transf, vol. 103, pp. 1359–1370, 2016. DOI:10.1016/j.ijheatmasstransfer.2016.08.040.
   Google Scholar
• R. Roth, G. Lenk, K. Cobry, and P. Woias, “Heat transfer in freestanding microchannels with in-line and staggered pin fin structures with clearance,” Int. J. Heat Mass Transf, vol. 67, pp. 1–15, 2013. DOI:10.1016/j.ijheatmasstransfer.2013.07.097.
   Google Scholar
• A. Kosar, C. Mishra, and Y. Peles, “Laminar flow across a bank of low aspect ratio micro pin fins,” J. Fluid Eng-T ASME, vol. 127, pp. 419–430, 2005. DOI:10.1115/1.1900139.
   Google Scholar
• Y. Peles, A. Kosar, C. Mishra, C. J. Kuo, and B. Schneider, “Forced convective heat transfer across a pin fin micro heat sink,” Int. J. Heat Mass Tran, vol. 48, pp. 3615–3627, 2005. DOI:10.1016/j.ijheatmasstransfer.2005.03.017.
   Google Scholar
• Z. G. Liu, C. W. Zhang, H. X. Zhao, and N. Guan, “Forced convective heat transfer characteristics in micro/mini cylinders group at low Reynolds number,” Nanosc. Microsc. Therm, vol. 16, pp. 165–180, 2012. DOI:10.1080/15567265.2012.683933.
   Google Scholar
• N. Guan, Z. G. Liu, and C. W. Zhang, “Numerical investigation on heat transfer of liquid flow at low Reynolds number in micro-cylinder-groups,” Heat Mass Transfer, vol. 48, pp. 1141–1153, 2012. DOI:10.1007/s00231-011-0956-8.
   Google Scholar
• K. S. Yang, W. H. Chu, I. Y. Chen, and C. C. Wang, “A comparative study of the airside performance of heat sinks having pin fin configurations,” Int. J. Heat Mass Tran, vol. 50, pp. 4661–4667, 2007. DOI:10.1016/j.ijheatmasstransfer.2007.03.006.
   Google Scholar
• N. Sahiti, F. Durst, and P. Geremia, “Selection and optimization of pin cross-sections for electronics cooling,” Appl. Therm. Eng, vol. 27, pp. 111–119, 2007. DOI:10.1016/j.applthermaleng.2006.05.018.
   Google Scholar
• A. B. Yang, L. G. Chen, Z. H. Xie, H. J. Feng, and F. R. Sun, “Constructal heat transfer rate maximization for cylindrical pin-fin heat sinks,” Appl. Therm. Eng, vol. 108, pp. 427–435, 2016. DOI:10.1016/j.applthermaleng.2016.07.150.
   Google Scholar
• A. Mohammadi and A. Kosar, “Hydrodynamic and thermal performance of microchannels with different in-line arrangements of cylindrical micro pin fins,” ASME J. Heat Transfer, vol. 138, pp. 1–17, 2016. DOI:10.1115/1.4034164.
   Google Scholar
• A. Mohammadi and A. Kosar, “Hydrodynamic and thermal performance of microchannels with different staggered arrangements of cylindrical micro pin fins,” ASME J. Heat Transfer, vol. 139, pp. 1–14, 2017. DOI:10.1115/1.4035655.
   Google Scholar
• K. G. Dobrosel′ skii, “Use of the PIV method for investigation of motion near a cylinder in transverse flow,” J. Eng. Phys. Thermophys, vol. 89, pp. 695–701, 2016. DOI:10.1007/s10891-016-1428-2.
   Google Scholar
• J. Soria, “An investigation of the near wake of a circular cylinder using a video based digital cross-correlation particle image velocimetry technique,” Exp. Therm. Fluid Sci, vol. 12, pp. 221–233, 1996. DOI:10.1016/0894-1777(95)00086-0.
   Google Scholar
• C. H. K. Williamson, “Vortex dynamics in the cylinder wake,” Annu. Rev. Fluid Mech, vol. 28, pp. 477–539, 1996. DOI:10.1146/annurev.fluid.28.1.477.
   Google Scholar
• S. Yagmur, S. Dogan, M. H. Aksoy, L. Goktepeli, and M. Ozgoren, “Comparison of flow characteristics around an equilateral triangular cylinder via PIV and Large Eddy Simulation methods,” Flow Meas. Instrum, vol. 55, pp. 23–36, 2017. DOI:10.1016/j.flowmeasinst.2017.04.001.
   Google Scholar
• A. Goharzadeh and A. Molki, “Measurement of fluid velocity development behind a circular cylinder using particle image velocimetry (PIV),” Eur. J. Phys, vol. 36, pp. 015001, 2015. DOI:10.1088/0143-0807/36/1/015001.
   Google Scholar
• V. Oruç, H. Akilli, and B. Sahin, “PIV measurements on the passive control of flow past a circular cylinder,” Exp. Therm. Fluid Sci, vol. 70, pp. 283–291, 2016. DOI:10.1016/j.expthermflusci.2015.09.019.
   Google Scholar
• N. A. Ozturk, C. Ozalp, C. Canpolat, and B. Sahin, “PIV measurements of flow through normal triangular cylinder arrays in the passage of a model plate-tube heat exchanger,”Int. J. Heat Fluid Fl, 61, 2016. 531–544. https://doi.org/10.1016/j.ijheatfluidflow.2016.06.013.
   Google Scholar
• D. Sinton, “Microscale flow visualization,” Microfluid. Nanofluid, vol. 1, pp. 2–21, 2005. DOI:10.1007/s10404-004-0009-4.
   Google Scholar
• S. J. Lee and Daichin, “Flow past a circular cylinder over a free surface: interaction between the near wake and the free surface deformation,” J. Fluid Struct, vol. 19, pp. 1049–1059, 2004. DOI:10.1016/j.jfluidstructs.2004.06.006.
   Google Scholar
• J. G. Santiago, S. T. Wereley, C. D. Meinhart, D. J. Beebe, and R. J. Adrian, “A particle image velocimetry system for microfluidics,” Exp. Fluids, vol. 25, pp. 316–319, 1998. DOI: 10.1007/s003480050235.
   Google Scholar
• M. Meis, F. Varas, A. Velázquez, and J. M. Vega, “Heat transfer enhancement in micro-channels caused by vortex promoters,” Int. J. Heat Mass Tran, vol. 53, pp. 29–40, 2011. DOI:10.1016/j.ijheatmasstransfer.2009.10.013.
   Google Scholar
• A. Armellini, L. Casarsa, and P. Giannattasio, “Low Reynolds number flow in rectangular cooling channels provided with low aspect ratio pin fins,” Int. J. Heat Fluid Fl, vol. 31, pp. 689–701, 2010. DOI:10.1016/j.ijheatfluidflow.2010.02.003.
   Google Scholar
• J. Jung, C.-J. Kuo, Y. Peles, and M. Amitay, “The flow field around a micropillar confined in a microchannel,” Int. J. Heat Fluid Fl, vol. 36, pp. 118–132, 2012. DOI:10.1016/j.ijheatfluidflow.2012.04.009.
   Google Scholar
• G. Xia, et al., “Micro-PIV visualization and numerical simulation of flow and heat transfer in three micro pin fin heat sinks,” Int. J. Therm. Sci, vol. 119, pp. 9–23, 2017. DOI:10.1016/j.ijthermalsci.2017.05.015.
   Google Scholar
• A. Renfer, et al., “Vortex shedding from confined micropin arrays,” Microfluid. Nanofluid, vol. 15, pp. 231–242, 2013. DOI:10.1007/s10404-013-1137-5.
   Google Scholar
• F. Y. Xu, Z. H. Pan, and H. Y. Wu, “Experimental investigation on the flow transition in different pin‑fin arranged microchannels,” Microfluid. Nanofluid, vol. 22, pp. 11, 2018. DOI:10.1007/s10404-017-2030-4.
   Google Scholar
• Y. L. Zhai, G. D. Xia, Z. Chen, and Z. H. Li, “Micro-PIV study of flow and the formation of vortex in micro heat sinks with cavities and ribs,” Int. J. Heat Mass Transf, vol. 98, pp. 380–389, 2016. DOI:10.1016/j.ijheatmasstransfer.2016.03.044.
   Google Scholar
• N. Guan, G. L. Jiang, Z. G. Liu, C. W. Zhang, and N. Ding, “The impact of contact angle on flow resistance reduction in hydrophobic micro pin fins,” Exp. Therm. Fluid Sci, vol. 77, pp. 197–211, 2016. DOI:10.1016/j.expthermflusci.2016.04.002.
   Google Scholar
• Z. G. Liu, N. Guan, C. W. Zhang, and G. L. Jiang, “The flow resistance and heat transfer characteristics of micro pin-fins with different cross-sectional shapes,” Nanosc. Microsc. Therm, vol. 19, pp. 221–243, 2015. DOI:10.1007/s00231-013-1115-1.
   Google Scholar
• N. K. C. Selvarasu, D. K. Tafti, and N. E. Blackwell, “Effect of pin density on heat-mass transfer and fluid flow at low Reynolds numbers in minichannels,” J. Heat Transfer, vol. 132, pp. 061702.1–061702.8, 2010. DOI:10.1115/1.4000949.
   Google Scholar