References
- An JH, Hong SP, Kim YJ, Budden PJ. 2011. Elastic stresses for 90 degrees elbows under in-plane bending. Int J Mech Sci. 53:762–776
- ANSYS. 2012. ANSYS User Manual (Release 14.0). Pennsylvania (PA): ANSYS Inc.
- ASME BPVC. 2010. Rules for construction of pressure vessels. Boiler and Pressure Vessel Code Section VIII division 2. New York (NY): American Petroleum Institute.
- Calladine CR. 1974. Limit analysis of curved tubes. J Mech Eng Sci. 16:85–87.
- Chattopadhyay J. 2002. The effect of internal pressure on in-plane collapse moment of elbows. Nuc Eng Des 212:133–144
- Duan ZX, Shen SM. 2006. Analysis and experiments on the plastic limit pressure of elbows. Int J Pres Ves Pip. 83:707–713.
- Firoozabad ES, Jeon BG, Choi HS, Kim NS. 2015. Seismic fragility analysis of seismically isolated nuclear power plantspiping system. Nuc Eng Des 284:264–279.
- Goodall IW. 1978. Lower bound limit analysis of curved tubes loaded by combined internal pressure and in-plane bending moment. Research Division Report RD/B/ N4360, Central Electricity Generating Board, UK.
- Guo C. 1999. Plastic limit loads for surface defect pipes and bends under combined loads of tension, bending, torsion and internal pressure (PhD thesis). East China University of Science and Technology, Shanghai, China.
- Han JJ, Lee KH, Kim NH, Kim YJ, Jeong DW, Budden PJ. 2012. Comparison of existing plastic collapse load solutions with experimental data for 90° elbows. Int J Pres Ves Pip. 89:19–27
- Han LH, Liu ZD. 1998. Limit load analysis for local wall thinning pipeline under internal pressure. Press Ves Technol. 15(4):1–4.
- Kim JW, Lee SH, Park CY. 2009. Experimental evaluation of the effect of local wall thinning on the failure pressure of elbows. Nuc Eng Des. 239:2737–2746.
- Kim YJ, Kim JH, An JH, Hong SP, Park CY. 2008. Effects of local wall thinning on plastic limit loads of elbows using geometrically linear FE limit analyses. Eng Fract Mech. 75:2225–2245
- Lee KH, Oh CS, Kim YJ, Yoon KB. 2009. Quantification of the yield strength-to-elastic modulus ratio effect on TES plastic loads from finite element limit analyses of elbows. Eng Fract Mech. 76:856–875.
- Oh CS, Kim YJ, Park CY. 2008. Shakedown limit loads for elbows under internal pressure and cyclic in-plane bending. Int J Pres Ves Pip. 85:394–405
- Srivastava A, Prabhakaran KM, Ghosh AK. 2011. Studies on the behavior of part-through circumferential crack at intrados in elbows under in-plane bending moment. Nuc Eng Des. 241:2386–2397.
- Wang Y, Liu S, Fan DS. 2005. Plastic limit load analysis of elbow with local thinning. J Beijing Univ Chem Technol. 32(1):62–65.
- Zhang L, Wang Y, Liu CJ, Liu C. 2001. Evaluation of local thinned pressurized elbows. Int J Pres Ves Pip. 78:697–703.