References
- Kumar R, Singh I. Productivity improvement of micro EDM process by improvised tool. Precis Eng. 2018;51:529–535. DOI:10.1016/j.precisioneng.2017.10.008
- D’Urso G, Merla C. Workpiece and electrode influence on micro-EDM drilling performance. Precis Eng. 2014;38:903–914.
- Gu L, Li L, Zhao W, et al. Electrical discharge machining of Ti6Al4V with a bundled electrode. Int J Mach Tools Manuf. 2012;53:100–106.
- Jahan MP, Wong YS, Rahman M. Evaluation of the effectiveness of low frequency workpiece vibration in deep hole micro-EDM drilling of tungsten carbide. J Manuf Processes. 2012;14:343–359.
- Bhosle RB, Sharma SB. Multi-performance optimization of micro-EDM drilling process of Inconel 600 alloy. Mater Today Proc. 2017;4:1988–1997.
- Chen Y-F, Lin Y-C. Surface modifications of Al–Zn–Mg alloy using combined EDM with ultrasonic machining and addition of TiC particles into the dielectric. J Mater Process Technol. 2009 May 1;209(9):4343–4350.
- Plaza S, Sanchez JA, Perez E, et al. Experimental study on micro EDM-drilling of Ti6Al4V using helical electrode. Precis Eng. 2014;38:821–827.