REFERENCES
- G. KURDJUMOV and G. SACHS: Z. Phys., 1930, 64, 225.
- E. C. BAIN: Trans. AIME, 1924, 70, 25.
- Z. NISHIYAMA: Sct Rep. Res. Inst. Tohoku Univ., 1934— 35, 23, 638.
- G. WASSERMANN: Arch. Eisenhüttenwes., 1933, 16, 647.
- A.-F. GOURGUES, %H. M. FLOWER, and T. C. LINDLEY: Mater. Sci. Technol, 2000, 16, 26–40.
- M. DE MEYER, D. VANDERSCHUEREN, and B. C. DE COOMAN: ISLI Int., 1999, 39, 813–822.
- J. MAHIEU, S. CLAESSENS, M. DE MEYER, and B. C. DE COOMAN: Proc. Conf. on 'Galvanised steel sheet forum — automotive', London, UK, May 2000, The Institute of Materials, 185–196.
- V. RANDLE and O. ENGLER: 'Introduction to texture analysis: macrotexture, microtexture and orientation mapping'; 2000, Reading, Gordon and Breach Science Publishers.
- P. VAN HOUTTE: 'The MTM—FHM software system version 2', Users Manual; 1995, Leuveu, Katholieke Universiteit Leuveu.
- B. HUTCHINSON, L. RYDE, E. LINDH, and K. TAGASHIRA: Mater. Sct Eng. A, 1998, A257, 9–17.
- M. DE MEYER, D. VANDERSCHUEREN, K. DE BLAUWE, and B. C. DE COOMAN: Proc. 41st Conf. on 'Mechanical working and steel processing', Baltimore, MD, USA, October 1999, ISS, 483 —491.
- L. KESTENS, N. YOSHINAGA, D. VANDERSCHUEREN, and B. C. DE COOMAN: Proc. Conf. on 'IF steels 2000', Pittsburgh, PA, USA, June 2000, Iron and Steel Society, 271–278.