References
- Putatunda SK: ‘Development of austempered ductile cast iron (ADI) with simultaneous high yield strength and fracture toughness by a novel two-step austempering process’, Mater. Sci. Eng. A, 2001, A315, (1), 70–80.
- Hamid AAS, Elliott R: ‘Influence of austenitizing temperature on austempering of on Mn–Mo–Cu alloyed ductile iron – part 2: mechanical properties’, Mater. Sci. Technol., 1997, 13, (1), 24–30.
- Kim YJ, Shin H, Park H, Lim JD: ‘Investigation into mechanical properties of austempered ductile iron (ADI) in accordance with austempering temperature’, Mater. Lett., 2008, 62, (3), 357–360.
- Trudel A, Gagné M: ‘Effect of composition and heat treatment parameters on the characteristics of ADI’, Can. Metall. Q., 1997, 36, (5), 289–298.
- Prasad RP, Putatunda SK: ‘Investigations on the fracture toughness of austempered ductile irons austenitized at different temperatures’, Mater. Sci. Eng., 2003, 349, (1), 136–149.
- Mallia J, Grech M, Smallman RE: ‘Effect of silicon content on transformation kinetics of austempered ductile iron’, Mater. Sci. Technol., 1998, 14, (5), 452–460.
- Zimba J, Simbi DJ, Navara E: ‘Austempered ductile iron: an alternative material for earth moving components’, Cement Concr. Compos., 2003, 25, (6), 643–649.
- Rong Z, Jiang Y, Lu D, Zhou RF, Li Z: ‘Development and characterization of a wear resistant bainite/martensite ductile iron by combination of alloying and a controlled cooling heat-treatment’, Wear, 2001, 250, (1–12), 529–534.
- Hasseb ASMA, Islam MA, Ali Bepari M: ‘Tribological behavior of quenched and tempered, in austempered ductile iron at the same hardness level’, Wear, 2000, 244, (1–2), 15–19.
- Fernandes FAP, Heck SC, Pereira RG, Picon CA, Nascente PAP, Casteletti LC: ‘Ion nitriding of a superaustenitic stainless steel: wear and corrosion characterization’, Surf. Coat. Technol., 2010, 250, (18–19), 3087–3090.
- Voigt RC, Loper CR: Proc. Int. Conf. on ‘Austempered ductile iron’, Metals Park, OH, USA, April 1994, ASM, 88–103.
- Elasayed AH, Megahed MM, Sadek AA, Abouelala KM: Mater. Des., 2009, 30, (6), 1866–1877.
- Garin JL, Mannheim RL: ‘Strain-induced martensite in ADI alloys’, J. Mater. Process. Technol., 2003, 143–144, 347–351.
- Lener YS, Kingsbury GR: ‘Wear resistance properties of austempered ductile iron’, J. Mater. Eng. Perform., 1998, 7, (1), 48–52.