References
- H. MARGOLIN, J. C. WILLIAMS, J. C. CHESTNUTT, and G. LuETIERING: in 'Ti 80' (Proc. 4th Int. Conf. on 'Titanium science and technology), (ed. H. Kimura and O. Izumi), 169; 1980, New York, AIME.
- H. W. STEMME: ‘Development of a formable sheet of titanium alloy’, Tech. Rep. AMFL-TR-73-296, Lockheed Georgia Co., January 1974.
- A. E. LEACH and R. J. SZPAKOWSKE J. Spacecraft Rockets, Nov.—Dec. 1983, 20, 583-588.
- A. SHAMES, M. ROSENBLUM, and W. B. TREPLE: in ‘Beta titanium alloys in the 80s’, (ed. R. R. Boyer and H. W. Rosenberg), 307; 1984, Warrendale, PA, TMS-AIME.
- R. S. KANEKO and C. A. wooDs: ‘Low temperature forming of beta titanium alloys’, NASA Cont. Rep. 3706, Lockheed California Co., September 1983.
- A. E. LEACH and J. D. McDONOUGH: Weldability of formable sheet Ti alloy Ti-15V-3Cr-3A1-3Sn', AMFL-TR-199, Bell Aerospace Textron, December 1978.
- P. K. POULOUSE and H. LIEBOWITZ: ‘Improvement of fracture toughness in high strength beta titanium alloys’, NAY AIR N00019-83-C-0177, School of Engineering and Applied Science, The George Washington University, Washington DC, March 1985.
- M. OKADA, D. BANERJEE, and J. C. WILLIAMS: in ‘Titanium in science and technology’ (5th Int. Conf. on 'Titanium), 1835; 1984, Oberursel, Deutsche Gesellschaft fiir Metallkunde.
- N. NIVA, H. YAGISITA, M. GUNJI, and K. ITO: ‘Mechanical properties of hot rolled Ti 15-3 alloy’, Annual Report of the Engineering Research Institute, Faculty of Engineering, University of Tokyo, Vol 45, 1986, 263.
- T. W. DUEIUNG and J. C. WILLIAMS: in ‘Beta titanium alloys of the 80s’, (ed. R. R. Boyer and H. W. Rosenberg), 19; 1984, Warrendale, PA, TMS-AIME.
- G. E. DIETER: ‘Mechanical metallurgy’, 186; 1986, New York, McGraw-Hill.
- D. meLEAN: ‘Grain boundaries in metals’, 107; 1957, Oxford, Clarendon Press.
- H. E ASHBY: ‘Physics of strength and plasticity’, (ed. A. S. Argon), 113; 1969, MIT Press.
- J. C. WILLIAMS, F. H. FROES, J. C. CHESTNUTT, C. G. RHODES, and R. G. BERRYMAN: in ‘Toughness and fracture behavior of titanium’, STP 651, 64; 1978, Philadelphia, PA, ASTM.