References
- J. G. COLLIER and J. R. THOME, Convective Boiling and Condensation, 3rd ed., Oxford (1994).
- “RELAP5/MOD3 Code Manual,” Vol. I–IV, NUREG/CR-5535, U.S. Nuclear Regulatory Commission (1998).
- E. L. BIBEAU and M. SALCUDEAN, “Subcooled Void Growth Mechanisms and Prediction at Low Pressure and Low Velocity,” Int. J. Multiphase Flow, 20, 837 (1994).
- E. KREPPER, “CFD Modelling of Subcooled Boiling,” presented at 10th Int. Topl. Mtg. Nuclear Reactor Thermal Hydraulics (NURETH-10), Seoul, Korea, October 5–9 2003.
- J. T. ROGERS, M. SALCUDEAN, Z. ABDULLAH, D. McLEOD, and D. POIRIER, “The Onset of Significant Void in Up-Flow Boiling of Water at Low Pressure and Velocities,” Int. J. Heat Mass Transfer,30, 11, 2247 (1987).
- J. Y. TU and G. H. YEOH, “On Numerical Modeling of Low-Pressure Subcooled Boiling Flows,” Int. J. Heat Mass Transfer, 45, 1197 (2002).
- S. HARI and Y. A. HASSAN, “Improvement of the Subcooled Boiling Model for Low-Pressure Conditions in Thermal-Hydraulic Codes,” Nucl. Eng. Des., 216, 139 (2002).
- B. KONCAR and B. MAVKO, “Modelling of Low-Pressure Subcooled Flow Boiling Using the RELAP5 Code,” Nucl. Eng. Des., 220, 255 (2003).
- O. ZEITOUN and M. SHOUKRI, “Axial Void Fraction Profile in Low Pressure Subcooled Flow Boiling,” Int. J. Heat Mass Transfer, 40, 869 (1997).
- M. ISHII, “One-Dimensional Drift-Flux Model and Constitutive Equations for Relative Motion Between Phases in Various Two-Phase Flow Regimes,” ANL-77-47, Argonne National Laboratory (1977).
- J. M. DOSTER and J. M. KAUFFMAN, “Numerical Stability of the Mixture Drift-Flux Equations,” Nucl. Sci. Eng., 132, 90 (1999).
- B. CHEXAL and G. LELLOUCHE, “A Full Range Drift-Flux Correlation for Vertical Flows,” EPRI NP-3989-SR, Electric Power Research Institute (1986).
- H. C. UNAL, “Maximum Bubble Diameter, Maximum Bubble Growth Time and Bubble Growth Rate,” Int. J. Heat Mass Transfer, 19, 643 (1976).
- G. H. YEOH and J. Y. TU, “Numerical Simulation of Subcooled Boiling Flow in an Annular Channel with the Influence of Bubble Coalescence and Break-up,” presented at 10th Int. Topl. Mtg. Nuclear Reactor Thermal Hydraulics (NURETH-10), Seoul, Korea, October 5–9 2003.
- P. SAHA, “A Simple Subcooled Boiling Model,” BNLNUREG-29859, Brookhaven National Laboratory (1981).
- A. S. DEVKIN and A. S. PODOSENOV, “RELAP5/MOD3 Subcooled Boiling Model Assessment,” NUREG/IA-0025, U.S. Nuclear Regulatory Commission (1998).
- V. PRODANOVIC, D. FRASER, and M. SALCUDEAN, “Bubble Behavior in Subcooled Flow Boiling of Water at Low Pressures and Flow Rates,” Int. J. Multiphase Flow, 28, 1 (2002).