28
Views
26
CrossRef citations to date
0
Altmetric
Technical Paper

Scaling Criteria for Two-Phase Flow Loops and Their Application to Conceptual 2×4 Simulation Loop Design

&
Pages 146-160 | Published online: 10 May 2017

References

  • R. P. ROSE, “Heat Transfer Problems Associated with the LOFT (Loss of Fluid Test) Program,” Proc. Conf. ASME-AIChE Heat Transfer, Los Angeles, California, August 8–11, 1965, American Society of Mechanical Engineers.
  • L. YBARRONDO, L. Y. GRIFFITH, P. FABIC and G. D. McPHERSON, “Examination of LOFT Scaling,” contributed by the Heat Transfer Division of the American Society of Mechanical Engineers at the Annual Winter Meeting, New York, November 1974.
  • A. N. NAHAVANDI, F. S. CASTELLANA and E. N. MORADKHANIAN, “Scaling Laws for Modeling Nuclear Reactor Systems,” Nucl. Sci. Eng., 72, 347 (1982).
  • M. ISHII and O. JONES, Jr., “Derivation and Application of Scaling Criteria for Two-Phase Flows,” Proc. Conf. Two-Phase Flows and Heat Transfer, Istanbul, Turkey, Vol. 1, p. 163, NATO Advanced Study Institute (1976).
  • M. ISHII and N. ZUBER, “Thermally Induced Flow Instabilities in Two-Phase Mixtures,” Proc. 4th Conf. Int. Heat Transfer, Paris, paper B5.ll (1970).
  • N. ZUBER, “Problems in Modeling of Small Break LOCA,” Heat Transfer in Nuclear Reactor Safety, p. 3, S. G. BANKOFF and N. H. AFGAN, Eds., Hemisphere Publishing Corporation, New York (1983).
  • M. ISHII and I. KATAOKA, “Scaling Criteria for LWR’s under Single Phase and Two-Phase Natural Circulation,” Proc. NRC/ANS Mtg. Basic Thermal-Hydraulic Mechanisms in L WR Analysis, Bethesda, Maryland, September 14–15, 1982, U.S. Nuclear Regulatory Commission (1983).
  • N. ZUBER and J. A. FINDLAY, “Average Volumetric Concentration in Two-Phase Flow Systems,” J. Heat Trans., 87, 453 (1965).
  • M. ISHII, “One-Dimensional Drift-Flux Model and Constitutive Equations for Relative Motion Between Phases in Various Two-Phase Flow Regimes,” ANL-77-47, Argonne National Laboratory (1977).
  • M. P. HEISLER and R. M. SINGER, “Facility Requirements for Natural Convection Shutdown Heat Removal System Testing,” Decay Heat Removal and Natural Convection in Fast Breeder Reactors, p. 113, Hemisphere Publishing Corporation, New York (1981).
  • M. P. HEISLER, “Development of Scaling Requirements for Natural Convection Liquid-Metal Fast Breeder Reactor Shutdown Heat Removal Test Facilities,” Nucl. Sci. Eng., 80, 347 (1982).
  • M. ISHII, “Foundation of Various Two-Phase Flow Models and Their Limitations,” Proc. NRC-EPRI Joint Conf. Simulation Methods for Nuclear Power Systems, EPRI WS-81-212, p. 3, Electric Power Research Institute (1981).
  • G. DAMKÖHLER, “Einflüsse der Stroemung, Diffusion und des Warmeubergenges aut die Leistung von Reaktionsoefen,” Zeitschrift for Elektrochemie, 42, 846 (1936).
  • N. ZUBER, F. W. STAUB, G. BIJWARD and P. G. KROEGER, “Steady State and Transient Void Fraction in Two-Phase System,” GEAP-5417, Vol. 1, General Electric Company (1967).
  • J. C. M. LEUNG, “Occurrence of Critical Heat Flux During Blowdown with Flow Reversal,” ANL-77-4, Ar-gonne National Laboratory (1977).
  • Y. KATTO, “A Generalized Correlation of Critical Heat Flux for Forced Convection Boiling in Vertical Uniformly Round Tube,” Int. J. Heat Mass Trans., 21, 1527 (1978).
  • K. MISHIMA and M. ISHII, “Critical Heat Flux Experiments Under Low Flow Conditions in a Vertical Annulus,” NUREG/CR-2647, ANL-82-6, U.S. Nuclear Regulatory Commission, Argonne National Laboratory (1982).
  • P. GRIFFITH, J. F. PEARSON and R. J. LEPKOWSKI, “Critical Heat Flux During a Loss-of-Coolant Accident,” Nucl. Saf., 18, 3, 298 (1977).
  • Y. TAITEL and A. E. DUKLER, “A Model for Predicting Flow Regime Transitions in Horizontal and Near Horizontal Gas-Liquid Flow,” AIChE J., 22, 47 (1976).
  • T. K. LARSON, J. R. WOLF and J. L. ANDERSON, “2 x 4 Loop Study,” EGG-SEMI-6005, EG&G Idaho Inc. (1982).
  • R. W. FOX and A. T. McDONALD, Introduction to Fluid Mechanics, 2nd ed., John Wiley & Sons, New York (1978).

Reprints and Corporate Permissions

Please note: Selecting permissions does not provide access to the full text of the article, please see our help page How do I view content?

To request a reprint or corporate permissions for this article, please click on the relevant link below:

Academic Permissions

Please note: Selecting permissions does not provide access to the full text of the article, please see our help page How do I view content?

Obtain permissions instantly via Rightslink by clicking on the button below:

If you are unable to obtain permissions via Rightslink, please complete and submit this Permissions form. For more information, please visit our Permissions help page.