References
- Schnell V B: ‘Design and calculation of centrifugal compressor machines’. Publ Mashinostroenie Moscow 1995 .
- Radzievskii V N et al : ‘Brazing of impellers of centrifugal machines’. Svar Proiz 1971 ( 3 ) 40 –41.
- Radzievskii V N et al : ‘Brazed impellers of centrifugal compressors made of low-alloy steels’. Khimicheskoe i Neftyannoe Mashinostroenie 1974 ( 8 ).
- Radzievskii V N et al : ‘Technology of production-brazed impellers of centrifugal compressors’. Khimicheskoe i Neftyannoe Mashinostroenie 1976 ( 12 ).
- Radzievskii V N and Rymar' V I: ‘High-temperature vacuum brazing of impellers of centrifugal compressors made of 07Kh16N6 steel’. Khimicheskoe i Neftyannoe Mashinostroenie 1978 ( 5 ).
- Myers L W and LaFlamme G: ‘Electron beam braze welding of compressor impellers’. IIW Document IV-732-98.
- Radzievskii V N et al : ‘High-temperature vacuum brazing of T-joints with a large fillet made of powder’. Svar Proiz 1991 ( 8 ) 5 –6.
- Radzievskii V N et al : ‘Special features of the formation of a thick-wall T-joint using high-temperature brazing and fusion welding’. Svar Proiz 2001 ( 4 ) 42 –46.
- Rymar' V I et al : ‘Interaction of Mn, Cr and Ti with air in the conditions of autovacuum heating in brazing’. Svar Proiz 1973 ( 11 ) 6 –8.
- Kuchuk-Yatsenko S I et al : ‘Self-cleaning to remove oxides from contact surfaces in solid-phase welding with heating’. Avt Svarka 1998 ( 2 ) 60 –23.
- Radzievskii V N and Gartsunov Yu F: ‘Cleaning the surface of carbon steel to remove the oxide film in autovacuum heating’. Svar Proiz 1990 ( 5 ) 31 –33.
- Radzievskii V N et al : ‘High-temperature brazing of steel with a Cu–Mn brazing alloy with a filler in the presence of a wide gap’. Avt Svarka 1997 ( 11 ) 18 –21.
- Radzievskii V N et al : ‘Effect of the dispersion of the filler made of the iron powder using a copper brazing alloy on the properties of the metal of a brazed joint’. Avt Svarka 1997 ( 8 ) 18 –22.