Comparing two intermittent drying schedules for timber drying quality

ABSTRACT

Intermittent drying techniques for drying timber may provide various benefits by improving timber quality and addressing energy efficiency through saving in energy consumption. The purpose of this study was to compare two intermittent drying schedules applied in the treatment of Eucalyptus delegatensis boards, through assessing surface and internal check development, moisture content (MC) profiles during drying, and timber distortions at the end of drying. The study used identical conditions during the heating phase at 45°C/60% relative humidity (RH), except for RH during the nonheating phase (80 and 90%). The results, discussed in this paper, analyzed the timber quality during and at the end of drying. The different RH during the nonheating phase did not generate a significant difference in MC at the case boards between the two drying schedules. The assessed quality of timber at the end of drying was based on AS/NZS 4787:2001. MC gradient, drying stress residual, internal checking and collapse were graded as class “A” (class A is the highest grade and D is the lowest). Bow, cupping, and spring were under the permissible levels based on grading standard AS 2082–2007. Measured data were validated using Drytek® simulation software showing MC movement in case boards.

KEYWORDS:

• Intermittent wood drying
• moisture content profile
• surface checking
• surface moisture content

Acknowledgment

The authors would like to thank Professor Yves Fortin from Université Laval, Québec, Canada, for his assistance and valuable comments.