Mechanical properties of Al–Si–Cu alloys produced by the continuous casting process with heating process

Abstract

The mechanical properties of aluminium alloys produced by the continuous cast process and heating process (heat-cast-sample) were investigated, where the aluminium alloys are heated continuously to high temperatures for 1 h immediately following heated mould continuous casting (HMC) and sand gravity casting (SGC). The material strength and ductility of the aluminium alloys were irregularly altered depending on the heating temperature. The mechanical properties decreased when the heating temperature increased to 400 °C and were then recovered when the temperature increased to 520 °C. However, these properties decreased again when heated to more than 540 °C. The mechanical properties of the HMC-heat-cast-sample showed overall higher than those for the SGC-sample. In addition to high tensile strength, high ductility was obtained for the HMC-520 °C samples compared with those for the as-cast-sample. Such changes were found to be directly attributable to the different severity of precipitate; moreover the crystal orientation was unchanged even after the heating process.

Keywords:

• Cast aluminium alloy
• heating process
• continuous casting
• mechanical property
• microstructural characteristic

Acknowledgement

Mr. Shaohua Wu at Okayama University has technically supported our experiments to give us some experimental results.