Experimentally validated numerical prediction of laser welding induced distortions of Al alloy parts for railcar body by inherent strain method combined with thermo-elastic-plastic FE model

Abstract

A laser welding with wire filler feeding was developed to replace traditional arc welding process for joining aluminium alloy railcar body components. A three-dimensional (3D) thermo-elastic-plastic finite element (FE) model was applied to compute the plastic strains of weld zone in a downsized aluminium alloy plate with butt-joint, T-joint and fillet-joint configurations, respectively, combined with corresponding experimental validations. The achieved plastic strains at the weld zone were then input as inherent strain loadings into elastic structural FE model of fully sized aluminium alloy railcar body components to predict the welding induced distortion with the experimentally measured out-of-plane distortions. The experimentally validated FE model was then further applied for optimizing the inverse pre-deformation of plates to counteract the welding induced deformation, finally to mitigate the welding distortion issues.

Keywords:

• Aluminium alloy
• laser welding
• finite-element model
• distortion
• inherent strain method

Acknowledgements

Dr. Fanrong Kong from ESAB Corporation provided valuable comments on the revision of this manuscript which are really appreciated.

Disclosure statement

No potential conflict of interest was reported by the author(s).

Additional information

Funding

No funding was received.