Polymer-precursor-derived (am-) SiC/TiC composites for resistive heaters in large volume multi-anvil high pressure/high-temperature apparatus

ABSTRACT

(Amorphous-)SiC/TiC composites for resistive tubular heaters in HP/HT experiments were obtained via a polymer-precursor process. A slurry consisting of a commercial SiC-precursor polymer (allylhydridopolycarbosilane, AHPCS) and TiC powder as conductive filler was applied to the inner walls of zirconia insulation tubes, using a centrifugation-casting method. Resistive coatings with homogeneous thickness of ∼200 μm were obtained. The heaters were tested in octahedral multi-anvil assemblies at ∼10 GPa with simultaneous recording of heating voltage and current. Up to a maximum temperature of ∼1800°C they showed temperature vs. power characteristics reproducible from batch to batch, with resistance decreasing from 0.08 to 0.02 Ω during heating. Microstructural characterization using SEM/EDX was carried out on the recovered SiC/TiC composite material, as well as on pristine resistive heaters directly after coating and curing to 230°C, and after additional pyrolysis at 900°C in argon. In all cases, a stable composite microstructure of an interpenetrating network of TiC particles with either silicon carbide polymer precursor or an amorphous SiC phase were found. The composites were characterized by XRD and thermogravimetry. Further improvement of coating procedure and materials combination (precursor/filler/insulator substrate) may result in advanced coatings, operational well beyond 2000°C.

KEYWORDS:

• Polymer-derived ceramics
• amorphous silicon carbide
• titanium carbide
• multi-anvil
• resistive heater furnaces
• high pressure and high-temperature

Disclosure statement

No potential conflict of interest was reported by the authors.

Additional information

Funding

This work was supported by the China Scholarship Council [grant number 2010704015].