The Use of D-optimal Design for Modeling and Analyzing the Tribological Characteristics of Journal Bearing Materials Lubricated by Nano-Based Biolubricants

ABSTRACT

Response surface methodology (RSM) based on a D-optimal design was employed to investigate the tribological characteristics of journal bearing materials such as brass, bronze, and copper lubricated by a biolubricant, chemically modified rapeseed oil (CMRO). The wear and friction performance were observed for the bearing materials tested with TiO₂, WS₂, and CuO nanoadditives dispersed in the CMRO. The tests were performed by selecting sliding speed and load as numerical factors and nano-based biolubricant/bearing materials as the categorical factor to evaluate the tribological characteristics such as the coefficient of friction (COF) and specific wear rate. The results showed that RSM based on a D-optimal design was instrumental in the selection of suitable journal bearing materials for a typical system, especially one lubricated by nano-based biolubricant. At a sliding speed of 2.0 m/s and load of 100 N, the bronze bearing material with CMRO containing CuO nanoparticles had the lowest COF and wear rate. In addition, scanning electron microscopy (SEM) examination of the worn bearing surfaces showed that the bronze bearing material lubricated with CMRO containing CuO nanoadditive is smoother than copper/brass bearing material.

KEYWORDS:

• Biolubricant
• d-optimal design
• pin-on-disc tribometer
• response surface methodology
• nanoparticles