High-Speed Elastohydrodynamic Lubrication by a Dilute Oil-in-Water Emulsion

ABSTRACT

When a concentrated contact is lubricated at low speed by an oil-in-water emulsion, a film of pure oil typically separates the surfaces (stage 1). At higher speeds, starvation occurs (stage 2) and the film is thinner than would be expected if lubricated by neat oil. However, at the very highest speeds, film thickness increases again (stage 3), though little is known for certain about either the film composition or the mechanism of lubrication, despite some theoretical speculation.

In this article, we report the film thickness in a ball-on-flat contact, lubricated by an oil-in-water emulsion, at speeds of up to 20 m/s, measured using a new high-speed test rig. We also investigated the sliding traction and the phase composition of the film, using fluorescent and infrared microscopy techniques.

Results show that, as the speed is increased, starvation is followed by a progressive change in film composition, from pure oil to mostly water. At the highest speeds, a film builds up that has a phase composition similar to the bulk emulsion. This tends to support the “microemulsion” view rather than the “dynamic concentration” theory.

KEYWORDS:

• Emulsion
• elastohydrodynamic lubrication
• starved lubrication
• cold rolling

Acknowledgements

The authors are grateful to Dr. Clive Hamer of PCS for his help in developing the high-speed test rig.