ABSTRACT
Thermo-hydraulic performance analysis of a tapered double layer microchannel heat sink (DL-MCHS) is done numerically. Water and Al2O3–H2O nanofluid coolants are used with uniform heat flux at the base of DL-MCHS. Comparatively higher heat transfer and lower pressure drop can be achieved considering temperature dependent thermo-physical properties. An overall performance factor is determined which indicates that though the tapered channel gives better thermal performance than straight channel, it is not always advantageous, if hydraulic performance is also considered, due to the increase in pressure drop penalty. Finally, from optimization study, maximum heat transfer is obtained at tapering factor of 0.32.
Nomenclature
A | = | area (m2) |
cp | = | specific heat (J kg−1 K−1) |
d | = | diameter (m) |
Eu | = | Euler number |
H | = | height of DL-MCHS (m) |
h | = | height of channel (m) |
= | mean heat transfer coefficient | |
k | = | thermal conductivity (W m−1 K−1) |
L | = | length of DL-MCHS (m) |
Nu | = | Nusselt number |
Pf | = | performance factor |
Pr | = | Prandtl number |
Greek symbols | ||
µ | = | dynamic viscosity (Pa.S) |
ρ | = | density (kg m−3) |
Subscript | ||
f | = | fluid |
in | = | inlet |
nf | = | nanofluid |
out | = | outlet |
p | = | particle |
s | = | solid |
Nomenclature
A | = | area (m2) |
cp | = | specific heat (J kg−1 K−1) |
d | = | diameter (m) |
Eu | = | Euler number |
H | = | height of DL-MCHS (m) |
h | = | height of channel (m) |
= | mean heat transfer coefficient | |
k | = | thermal conductivity (W m−1 K−1) |
L | = | length of DL-MCHS (m) |
Nu | = | Nusselt number |
Pf | = | performance factor |
Pr | = | Prandtl number |
Greek symbols | ||
µ | = | dynamic viscosity (Pa.S) |
ρ | = | density (kg m−3) |
Subscript | ||
f | = | fluid |
in | = | inlet |
nf | = | nanofluid |
out | = | outlet |
p | = | particle |
s | = | solid |