REFERENCES
- ARMABEGO , E. J. A. , and BROWN , R. H. , 1969 , The Machining of Metals ( Englewood Cliffs , N.J. Prentice-Hall, Inc. ).
- BREWER , R. C. , 1958 , On the economics of the basic turning operation , Trans. Am. Soc. meek. Engrs. , 80 , 479 .
- BROWN , R. H. , 1962 , On the selection of economical machining rates , Int. J. Prod. Res. , 1 , 1 .
- CONWAY , RICHARD W. , MAXWELL , WILLIAM L. , MILLER , LOUIS W. , 1967 , Theory of Scheduling , ( Reading , Mass. Addison-Wesley Publishing Co. ), p. 21 .
- GILBERT , W. W. , 1950 , Economics of machining , Machining Theory and Practice ( American Society of Metals ).
- MONAUGHTON , ROBERT , 1959 , Scheduling with deadlines and loss functions , Mgmt Sci. , 6 , 1 .
- NEWHAUSER , GEORGE L. , 1967 , Introduction to Dynamic Programming ( New York John Wiley and Sons, Inc. ).
- OKUSHIMA , K. , and HITOMI , K. , 1964 , Analysis of maximum profit cutting speed , Int. J. Prod. Res. , 1 , 73 .
- Wu , S. M. , and ERMER , D. S. , 1966 , Maximum profit as the criterion in the determination of optimum cutting conditions , Trans. Am. Soc. mech. Engrs , 88 , 435 .