References
- Li S, He J, Wan J, et al. Dynamic modeling of AP1000 steam generator for control system design and simulation. Ann Nucl Energy. 2017;109:648–657.
- Zhao F, Zhao C, Bo H. Numerical investigation of the separation performance of full-scale AP1000 steam-water separator. Ann Nucl Energy. 2018;111:204–223.
- Wang WW, Su GH, Tian WX, et al. Research on thermal hydraulic behavior of small-break LOCAs in AP1000. Nucl Eng Des. 2013;263(1):380–394.
- Kao MT, Wu CY, Chieng CC, et al. CFD analysis of PWR reactor vessel upper plenum sections: flow simulation in control rods guide tubes. 18th International Conference on Nuclear Engineering, Xi'an, China. American Society of Mechanical Engineers; 2010. p. 499–506.
- Patankar SV. Numerical heat transfer and fluid flow. Washington (DC): Hemisphere; 1980. p. 140.
- Sohankar A, Davidson L. Effect of inclined vortex generators on heat transfer enhancement in a three-dimensional channel. Numer Heat Tr, Part A: Appl. 2001;39(5):433–448.
- Islam MS, Hino R, Haga K, et al. Experimental study on heat transfer augmentation for high heat flux removal in rib-roughened narrow channels. J Nucl Sci Technol. 1998;35(9):671–678.
- Xiao-Hang WU, Xiao-Hua FU. Effect of structure and thermal properties of the electrically heated rod on transient thermal-hydraulic experiment. Chin J Nucl Sci Eng. 2004;24(3):235–241.
- Fujun WANG. Analysis of computational fluid dynamics-principle and application of CFD. Beijing: Tsinghua University Press; 2004. p. 24–158.
- Oka YK. Design concept of once-through cycle super-critical pressure light coolant cooled reactors. Proc of SCR-2000. Tokyo: International Atomic Energy Agency (IAEA); 2000 Nov 6–8. p. 1–22.
- Tamagno P, Jean CDS, Bouland O, et al. From low- to high-energy nuclear data evaluations. Eur Phys J. 2015;51(12):1–24.
- Jeong HY, Ha KS, Kwon YM, et al. A dominant geometrical parameter affecting the turbulent mixing rate in rod bundles. Heat Mass Tr. 2007;50:908–918.
- Tsai FJ, Min L, Liu HC. Simulation of the in-vessel retention device heat-removal capability of AP-1000 during a core meltdown accident. Ann Nucl Energy. 2016;99:455–463.
- Giuli MD, Sumini M, Rosa FD. Modeling of AP1000 and simulation of 10-inch cold leg small break LOCA using the CESAR thermal-hydraulic module of ASTEC. Prog Nucl Energy. 2015;83(3):387–397.
- Xie H. Numerical simulation of AP1000 LBLOCA with SCDAP/RELAP 4.0 code. J Nucl Sci Technol. 2017;54(9):1–8.
- Xu DT, Li HB, Yang J, et al. Numerical simulation of heat transfer to SCW in 4-rod bundle. At Energy Sci Technol. 2015;49(2):292–296.
- Jimenez G, Bocanegra R, Fernandez K, et al.. Development of a PWR-W and an AP1000 (R) containment building 3D model with a CFD code for best-estimate thermal-hydraulic analysis. 2014 22nd International Conference on Nuclear Engineering, Prague, Czech Republic. American Society of Mechanical Engineers, 2014. V004T10A015 – V 0 04T10A015.
- Liu Y, Zhao D, Liu W, et al. Theoretical study on critical heat flux in vertical narrow tube with axial power step. Nucl Power Eng. 2016;4:6–10.
- Liu R, Huang M, Peng Y, et al. Analysis for crack growth regularities in the nozzle-cylinder intersection area of reactor pressure vessel. Ann Nucl Energy. 2018;112:779–793.
- Mohanty S, Soppet WK, Majumdar S, et al. Full-scale 3-D finite element modeling of a two-loop pressurized water reactor for heat transfer, thermal–mechanical cyclic stress analysis, and environmental fatigue life estimation. Nucl Eng Des. 2015;295:374–387.
- Lee KB, Jang HC. A numerical prediction on the turbulent flow in closely spaced bare rod arrays by a nonlinear k-ε model. Nucl Eng Des. 1997;172(3):351–357.
- Fujun W. Analysis of computational fluid dynamics principle and application of CFD. Beijing: Tsinghua University Press;2004 24–158. in Chinese.
- Sun L, Peng M, Xia G, et al. Numerical study on coolant flow distribution at the core inlet for an integral pressurized water reactor. Nucl Eng Technol. 2016;49(1):71–81.
- Chao Y, Zhai Y, Yang L, et al. Thermal hydraulics characteristics simulation of CPR1000 using CFD method. 21st International Conference on Nuclear Engineering, Chengdu, China. American Society of Mechanical Engineers, 2013. V004T09A107-V004T09A107.
- Jianquan L, Jingda S, Liuliu Z, et al. DNBR characteristics research based on the MATLAB on AP1000 nuclear power unit reactor. J Shanghai Univ Elec Power. 2015;31(6):505–510. in Chinese.
- Jianquan L, Jingda S, Jiguo Z, et al. CHF characteristic analysis of 1000 MW nuclear power plant reactor based on MATLAB. J Shanghai Univ Elec Power. 2018;31(5):245–250. in Chinese.
- Jo SW, Yong KL, Jo JC, Numerical simulation of the transient phase change heat transfer in a pressurized water reactor core during a loss-of-coolant accident, ASME 2011 Pressure Vessels and Piping Conference Maryland, USA. American Society of Mechanical Engineers, 2011. p. 335–341.
- Jianquan LIU, Qijun HUO, Tao ZHOU, et al. Simulation study of enthalpy gain characteristics on nuclear power 1000 MW unit pressurized water reactor loop flow deviation. Proc CSEE. 2015;35(16):4139–4146. in Chinese.