References
- ANSI Z1.4 (1971), “Sampling Procedures and Tables for Inspection by Attributes,” American National Standards Institute, New York, New York.
- ANSI/ASQC A2 (1978), “American National Standard, Terms, Symbols and Definitions for Acceptance Sampling,” American Society for Quality Control, Milwaukee, Wisconsin.
- ANSI/ASQC Z1.4 (1981), “Sampling Procedures and Tables for Inspection by Attributes,” American Society for Quality Control, Milwaukee, Wisconsin.
- ANSI/ASQC Z1.9 (1980), “Sampling Procedures and Tables for Inspection by Variables for Percent Defective,” American Society for Quality Control, Milwaukee, Wisconsin.
- Dodge, H. F. (1959), “A General Procedure for Sampling by Attributes—Based on the AQL Concept,” Technical Report No. 10, Statistics Center, Rutgers—The State University, New Brunswick, New Jersey, December 15, 1959.
- Hahn, G. R. and Schilling, E. G. (1975), “An Introduction to the MIL-STD-105D Acceptance Sampling Scheme,” ASTM Standardization News, Vol. 3, No. 9, pp. 20–30.
- Hill, I. D. (1962), “Sampling Inspection and Defence Specification DEF-131,” Journal of the Royal Statistical Society (Series A), 125, Part I, pp. 31–73.
- Hill, I. D. (1973), “The Design of MIL-STD-105D Sampling Tables,” Journal of Quality Technology, Vol. 5, No. 2, pp. 80–83.
- MIL-HDBK-53 (1963), “Guide to Sampling Inspection, Quality and Reliability Assurance Handbook,” Office of the Assistant Secretary of Defense (Installations and Logistics), U.S. Department of Defense, Washington, D.C.
- MIL-STD-105D (1963), “Military Standard, Sampling Procedures and Tables for Inspection by Attributes,” United States Department of Defense, U.S. Government Printing Office, Washington, D.C.
- MIL-STD-414 (1957), “Military Standard, Sampling Procedures and Tables for Inspection by Variables for Percent Defective,” United States Department of Defense, U.S. Government Printing Office, Washington, D.C.
- Pabst, W. R., Jr. (1963), “MIL-STD-105D,” Industrial Quality Control, Vol. 20, No. 5, pp. 4–9.
- Schilling, E. G. (1981), “Revised Variables Acceptance Sampling Standards—ANSI Z1.9(1980) and ISO 3951(1980),” Journal of Quality Technology, Vol. 13, No. 2, pp. 131–138.
- Schilling, E. G. (1982), Acceptance Sampling in Quality Control, Marcel Dekker, New York, pp. 277–306.
- Schilling, E. G. (1982a), “The Synergism of ANSI/ASQC Z1.9 and ANSI/ASQC Z1.4,” American Society for Quality Control Technical Conference Transactions, Detroit, Michigan, pp. 602–605.
- Schilling, E. G. and Sheesley, J. H. (1978), “The Performance of MIL-STD-105D Under the Switching Rules,” Journal of Quality Technology, Part 1, Vol. 10, No. 2, pp. 76–83; and Part 2, Vol. 10, No. 3, pp. 104–124.
- Stephens, K. S. and Larson, K. E. (1967), “An Evaluation of the MIL-STD-105D System of Sampling Plans,” Industrial Quality Control, Vol. 23, No. 7, pp. 310–319.