References
- S. NUKIYAMA, “The Maximum and Minimum Values of the Heat Q Transmitted from Metal to Boiling Water Under Atmospheric Pressure,” Int. J. Heat Transfer, 27, 7, 959 (1984); https://doi.org/10.1016/0017-9310(84)90112-1.
- K. N. RAINEY and S. M. YOU, “Effects of Heater Size and Orientation on Pool Boiling Heat Transfer from Microporous Coated Surfaces,” Int. J. Heat Transfer, 44, 14, 2589 (2001); https://doi.org/10.1016/S0017-9310(00)00318-5.
- B. J. JONES, J. P. McHALE, and S. V. GARIMELLA, “The Influence of Surface Roughness on Nucleate Pool Boiling Heat Transfer,” J. Heat Transfer, 131, 12, 315 (2009); https://doi.org/10.1115/1.3220144.
- H. J. JO et al., “A Study of Nucleate Boiling Heat Transfer on Hydrophilic, Hydrophobic and Heterogeneous Wetting Surfaces,” Int. J. Heat Transfer, 54, 25–26, 5643 (2011); https://doi.org/10.1016/j.ijheatmasstransfer.2011.06.001.
- L. DONG, X. QUAN, and P. CHENG, “An Experimental Investigation of Enhanced Pool Boiling Heat Transfer from Surfaces with Micro/Nano-Structures,” Int. J. Heat Transfer, 71, 4, 189 (2014); https://doi.org/10.1016/j.ijheatmasstransfer.2013.11.068.
- B. SHEN et al., “Bubble Activation from a Hydrophobic Spot at ‘Negative’ Surface Superheats in Subcooled Boiling,” Appl. Therm. Eng., 88, 230 (2015); https://doi.org/10.1016/j.applthermaleng.2014.10.054.
- P. A. RAGHUPATHI and S. G. KANDLIKAR, “Effect of Thermophysical Properties of the Heater Substrate on CHF in Pool Boiling,” J. Heat Transfer, 139, 11, 111502 (2017); https://doi.org/10.1115/1.4036653.
- J. WEISMAN and Y. K. KAO, “Transition Boiling Heat Transfer During Reflooding Transients,” AIChE J., 32, 2, 344 (1986); https://doi.org/10.1002/(ISSN)1547-5905.
- J. F. LU, B. BOUROUGA, and J. DING, “Transient Boiling Heat Transfer Performances of Subcooled Water During Quenching Process,” Int. Commun. Heat Mass Transfer, 48, 48, 15 (2013); https://doi.org/10.1016/j.icheatmasstransfer.2013.08.016.
- C. W. HIRT and B. D. NICHOLS, “Volume of Fluid (VOF) Method for the Dynamics of Free Boundaries,” J. Comput. Phys., 39, 1, 201 (1981); https://doi.org/10.1016/0021-9991(81)90145-5.
- G. SON, V. K. DHIR, and N. RAMANUJAPU, “Dynamics and Heat Transfer Associated with a Single Bubble During Nucleate Boiling on a Horizontal Surface,” ASME J. Heat Transfer, 121, 3, 623 (1999); https://doi.org/10.1115/1.2826025.
- X. QUAN, G. CHEN, and P. CHENG, “A Thermodynamic Analysis for Heterogeneous Boiling Nucleation on a Superheated Wall,” Int. J. Heat Transfer, 54, 21–22, 4762 (2011); https://doi.org/10.1016/j.ijheatmasstransfer.2011.05.026.
- G. HAZI and A. MARKUS, “On the Bubble Departure Diameter and Release Frequency Based on Numerical Simulation Results,” Int. J. Heat Transfer, 52, 5, 1472 (2009); https://doi.org/10.1016/j.ijheatmasstransfer.2008.09.003.
- S. GONG and P. CHENG, “Numerical Investigation of Droplet Motion and Coalescence by an Improved Lattice Boltzmann Model for Phase Transitions and Multiphase Flows,” Comput. Fluids, 53, 1, 93 (2012); https://doi.org/10.1016/j.compfluid.2011.09.013.
- S. GONG and P. CHENG, “A Lattice Boltzmann Method for Simulation of Liquid-Vapor Phase-Change Heat Transfer,” Int. J. Heat Transfer, 55, 17–18, 4923 (2012); https://doi.org/10.1016/j.ijheatmasstransfer.2012.04.037.
- S. GONG and P. CHENG, “Lattice Boltzmann Simulation of Periodic Bubble Nucleation, Growth and Departure from a Heated Surface in Pool Boiling,” Int. J. Heat Transfer, 64, 3, 122 (2013); https://doi.org/10.1016/j.ijheatmasstransfer.2013.03.058.
- S. GONG and P. CHENG, “Lattice Boltzmann Simulations for Surface Wettability Effects in Saturated Pool Boiling Heat Transfer,” Int. J. Heat Transfer, 85, 635 (2015); https://doi.org/10.1016/j.ijheatmasstransfer.2015.02.008.
- S. GONG and P. CHENG, “Two-Dimensional Mesoscale Simulations of Saturated Pool Boiling from Rough Surfaces. Part II: Bubble Interactions Above Multi-Cavities,” Int. J. Heat Transfer, 100, 938 (2016); https://doi.org/10.1016/j.ijheatmasstransfer.2016.04.082.
- C. ZHANG and P. CHENG, “Mesoscale Simulations of Boiling Curves and Boiling Hysteresis Under Constant Wall Temperature and Constant Heat Flux Conditions,” Int. J. Heat Transfer, 110, 319 (2017); https://doi.org/10.1016/j.ijheatmasstransfer.2017.03.039.
- P. CHENG, C. ZHANG, and S. GONG, “Lattice Boltzmann Simulations of Interfacial Effects on Saturated Pool Boiling Curves for Horizontal Heated Surfaces,” J. Heat Transfer, 139, 11, 110801 (2017); https://doi.org/10.1115/1.4036578.
- X. MA et al., “Mesoscale Simulations of Saturated Pool Boiling Heat Transfer Under Microgravity Conditions,” Int. J. Heat Transfer, 114, 453 (2017); https://doi.org/10.1016/j.ijheatmasstransfer.2017.06.019.
- L. LI et al., “Conjugate Heat and Mass Transfer in the Lattice Boltzmann Equation Method,” Phys. Rev. E, 89, 4, 043308 (2014); https://doi.org/10.1103/PhysRevE.89.043308.
- S. GONG and P. CHENG, “Direct Numerical Simulations of Pool Boiling Curves Including Heater’s Thermal Responses and the Effect of Vapor Phase’s Thermal Conductivity,” Int. Commun. Heat Mass Transfer, 87, 61 (2017); https://doi.org/10.1016/j.icheatmasstransfer.2017.06.023.
- P. J. BERENSON, “Film Boiling Heat Transfer from a Horizontal Surface,” J. Heat Transfer, 83, 3, 351 (1961); https://doi.org/10.1115/1.3682280.
- A. KUPERSHTOKH, “Calculations of the Action of Electric Forces in the Lattice Boltzmann Equation Method Using the Difference of Equilibrium Distribution Functions,” Proc. 7th Int. Conf. Modern Problems of Electrophysics and Electrohydrodynamics of Liquids, St. Petersburg, Russia, 2003, p. 152 (2003).
- P. YUAN and L. SCHAEFER, “Equations of State in a Lattice Boltzmann Model,” Phys. Fluids, 18, 4, 329 (2006); https://doi.org/10.1063/1.2187070.
- V. P. CAREY, Liquid-Vapor Phase-Change Phenomena: An Introduction to the Thermophysics of Vaporization and Condensation Processes in Heat Transfer Equipment, Hemisphere Publishing Corporation (2007)
- Q. LOU, Z. GUO, and B. SHI, “Evaluation of Outflow Boundary Conditions for Two-Phase Lattice Boltzmann Equation,” Phys. Rev. E, 87, 6, 70 (2013); https://doi.org/10.1103/PhysRevE.87.063301.
- X. HE et al., “Analytic Solutions of Simple Flows and Analysis of Nonslip Boundary Conditions for the Lattice Boltzmann BGK Model,” J. Stat. Phys., 87, 1, 115 (1997); https://doi.org/10.1007/BF02181482.
- T. B. DREW and A. C. MUELLER, “Boiling,” Trans. AIChE, 33, 449 (1937).
- J. D. BERNARDIN and I. MUDAWAR, “The Leidenfrost Point: Experimental Study and Assessment of Existing Models,” J. Heat Transfer, 121, 4, 894 (1999); https://doi.org/10.1115/1.2826080.
- N. ZUBER, “Hydrodynamic Aspects of Boiling Heat Transfer Thesis,” University of California, Los Angles, Ramo-Wooldridge Corporation (1959).
- J. M. RAMILISON and J. H. LIENHARD, “Transition Boiling Heat Transfer and the Film Transition Regime,” J. Heat Transfer, 109, 3, 746 (1987); https://doi.org/10.1115/1.3248153.
- W. M. ROHSENOW, “A Method of Correlating Heat-Transfer Data for Surface Boiling of Liquids,” Trans. ASME, 74, 969 (1951).
- S. G. KANDLIKAR, “A Theoretical Model to Predict Pool Boiling CHF Incorporating Effects of Contact Angle and Orientation,” J. Heat Transfer, 123, 6, 1071 (2000); https://doi.org/10.1115/1.1409265.
- Y. NAM et al., “Experimental and Numerical Study of Single Bubble Dynamics on a Hydrophobic Surface,” J. Heat Transfer, 131, 12, 315 (2009); https://doi.org/10.1115/1.3216038.
- S. K. R. CHOWDHURY and R. H. S. WINTERTON, “Surface Effects in Pool Boiling,” Int. J. Heat Transfer, 28, 10, 1881 (1985); https://doi.org/10.1016/0017-9310(85)90210-8.
- S. H. KIM et al., “Study of Leidenfrost Mechanism in Droplet Impacting on Hydrophilic and Hydrophobic Surfaces,” Int. J. Air-Conditioning Refrig., 21, 04, 1350028 (2013); https://doi.org/10.1142/S2010132513500284.
- I. I. GOGONIN, “Dependence of the Critical Heat Flux at Boiling on the Coolant Physical Properties,” Thermophys. Aeromech., 16, 1, 111 (2009).
- F. TACHIBANA, M. AKIYAMA, and H. KAWAMURA, “Non-Hydrodynamic Aspects of Pool Boiling Burnout,” J. Nucl. Sci. Technol., 4, 3, 121 (1967); https://doi.org/10.1080/18811248.1967.9732708.
- I. GOLOBIČ and A. E. BERGLES, “Effects of Heater-Side Factors on the Saturated Pool Boiling Critical Heat Flux,” Exp. Therm. Fluid Sci., 15, 1, 43 (1997); https://doi.org/10.1016/S0894-1777(96)00170-7.
- J. H. SANG and H. C. NO, “A Dry-Spot Model for Transition Boiling Heat Transfer in Pool Boiling,” Int. J. Heat Transfer, 41, 23, 3771 (1998); https://doi.org/10.1016/S0017-9310(98)00101-X.
- H. O’HANLEY et al., “Separate Effects of Surface Roughness, Wettability, and Porosity on the Boiling Critical Heat Flux,” Appl. Phys. Lett., 103, 2, 024102 (2013); https://doi.org/10.1063/1.4813450.
- P. J. BERENSON, “Transition Boiling Heat Transfer from a Horizontal Surface,” Proc. ASME-AIChE Heat Transfer Conf., Buffalo, New York, 1960, p. 18 (1960).
- M. MANN, K. STEPHAN, and P. STEPHAN, “Influence of Heat Conduction in the Wall on Nucleate Boiling Heat Transfer,” Int. J. Heat Transfer, 43, 12, 2193 (2000); https://doi.org/10.1016/S0017-9310(99)00292-6.