The Effect of Transient Power Hotspots on the Heat Transfer Coefficient during Flow Boiling Inside Single Microscale Channels

References

• Y. J. Kim, Y. K. Joshi, A. G. Fedorov, Y. J. Lee, and S. K. Lim, “Thermal characterization of interlayer microfluidic cooling of three-dimensional integrated circuits with nonuniform heat flux,” J. Heat Transfer, vol. 132, no. 4, pp. 1–9, 041009, 2010.
   PubMed Web of Science ®Google Scholar
• C. S. Sharma et al., “A novel method of energy efficient hotspot-targeted embedded liquid cooling for electronics: an experimental study,” Int. J. Heat Mass Transfer, vol. 88, no. 1, pp. 684–694, 2015.
   Google Scholar
• H. Baig, K. C. Heasman, and T. K. Mallick, “Non-uniform illumination in concentrating solar cells,” Renewable Sustainable Energy Rev., vol. 16, no. 8, pp. 5890–5909, 2012.
   Web of Science ®Google Scholar
• H. M. Bahaidarah, A. A. Baloch, and P. Gandhidasan, “Uniform cooling of photovoltaic panels: a review,” Renewable Sustainable Energy Rev., vol. 57, no. 1, pp. 1520–1544, 2016.
   Google Scholar
• A. Royne, and C. J. Dey, “Design of a jet impingement cooling device for densely packed PV cells under high concentration,” Sol. Energy, vol. 81, no. 8, pp. 1014–1024, 2007.
   Web of Science ®Google Scholar
• J. M. Koo et al., “Convective boiling in microchannel heat sinks with spatially-varying heat generation,” in The Eighth Intersociety Conf. Therm. Thermomechanical Phenom. Electron. Syst., 7th August, San Diego, CA, USA, pp. 341–346, 2002.
   Google Scholar
• T. Alam, P. S. Lee, C. R. Yap, and L. Jin, “A comparative study of flow boiling heat transfer and pressure drop characteristics in microgap and microchannel heat sink and an evaluation of microgap heat sink for hotspot mitigation,” Int. J. Heat Mass Transfer, vol. 58, no. 1, pp. 335–347, 2013.
   Web of Science ®Google Scholar
• C. S. Sharma et al., “A novel method of energy efficient hotspot-targeted embedded liquid cooling for electronics: an experimental study,” Int. J. Heat Mass Transfer, vol. 88, no. 1, pp. 684–694, 2015.
   Google Scholar
• S. N. Ritchey, J. A. Weibel, and S. V. Garimella, “Effects of non-uniform heating on the location and magnitude of critical heat flux in a microchannel heat sink,” Int. J. Micro-Nano Scale Transport, vol. 5, no. 3, pp. 95–108, 2015. doi:10.1260/1759-3093.5.3.95.
   Google Scholar
• D. Bogojevic et al., “Experimental investigation of non-uniform heating effect on flow boiling instabilities in a microchannel-based heat sink,” Int. J. Therm. Sci., vol. 50, no. 3, pp. 309–324, 2011.
   Web of Science ®Google Scholar
• E. S. Cho, J. W. Choi, J. S. Yoon, and M. S. Kim, “Experimental study on microchannel heat sinks considering mass flow distribution with non-uniform heat flux conditions,” Int. J. Heat Mass Transfer, vol. 53, no. 9, pp. 2159–2168, 2010.
   Web of Science ®Google Scholar
• E. Costa-Patry, S. Nebuloni, J. Olivier, and J. R. Thome, “On-chip two-phase cooling with refrigerant 85 µm-wide multi-microchannel evaporator under hot-spot conditions,” IEEE Trans. on Components, Packaging Manuf. Technol., vol. 2, no. 2, pp. 311–320, 2012. doi:10.1109/TCPMT.2011.2173572.
   Web of Science ®Google Scholar
• Y. J. Lee, P. S. Lee, and S. K. Chou, “Hotspot mitigating with obliquely finned microchannel heat sink—an experimental study,” IEEE Trans. Components, Packaging Manuf. Technol., vol. 3, no. 8, pp. 1332–1341, 2013. doi:10.1109/TCPMT.2013.2244164.
   Web of Science ®Google Scholar
• J. L. Miler et al., “Effects of transient heating on two-phase flow response in microchannel heat exchangers,” in ASME 2009 InterPACK Conf., 19–23 July, vol. 2, San Francisco, CA, USA, 2009, pp. 563–569.
   Google Scholar
• D. F. Sempértegui-Tapia, and G. Ribatski, “Flow boiling heat transfer of R134a and low GWP refrigerants in a horizontal micro-scale channel,” Int. J. Heat Mass Transfer, vol. 108, pp. 2417–2432, 2017.
   Web of Science ®Google Scholar
• V. Gnielinski, “New equations for heat and mass-transfer in turbulent pipe and channel flow,” Int. Chem. Eng., vol. 16, no. 2, pp. 359–368, 1976.
   Web of Science ®Google Scholar
• A. Avci and I. Karagoz, “A novel explicit equation for friction factor in smooth and rough pipes,” J. Fluids Eng., vol. 131, no. 6, pp. 1–4, 061203, 2009.
   Web of Science ®Google Scholar
• F. T. Kanizawa and G. Ribatski, “Void fraction predictive method based on the minimum kinetic energy,” J. Brazilian Soc. Mech. Sci. Eng., vol. 38, no. 1, pp. 209–225, 2016. doi:10.1007/s40430-015-0446-x.
   Web of Science ®Google Scholar
• D. F. Sempértegui-Tapia and G. Ribatski, “Two-phase frictional pressure drop in horizontal microscale channels: experimental data analysis and prediction method development,” Int. J. Refrig., vol. 79, no. 1, pp. 143–163, 2017.
   Google Scholar
• MATLAB, version 2014b, Natick, MA: The MathWorks Inc., 2014.
   Google Scholar
• I. H. Bell, J. Wronski, S. Quoilin, and V. Lemort, “Pure and pseudo-pure fluid thermophysical property evaluation and the open-source thermophysical property library CoolProp,” Ind. Eng. Chem. Res., vol. 53, no. 6, pp. 2498–2508, 2014. doi:10.1021/ie4033999.
   PubMed Web of Science ®Google Scholar
• R. B. Abernethy and J. W. Thompson, Handbook of Uncertainty in Gas Turbine Measurements, Arnold Air Force Station, TN: Arnold Engineering Development Center, 1973.
   Google Scholar
• B. N. Taylor and C. E. Kuyatt, Guidelines for evaluating and expressing the uncertainty of NIST measurement results. Gaithersburg, MD: US Department of Commerce, Technology Administration, National Institute of Standards and Technology, pp. 1–25, 1994.
   Google Scholar
• B. S. Petukhov, V. A. Kurganov, and A. I. Gladuntsov, “Heat transfer in turbulent pipe flow of gases with variable properties,” Heat Transfer Sov. Res, vol. 5, pp. 109–116, 1973.
   Google Scholar
• F. W. Dittus and L. M. K. Boelter, “Heat transfer in automobile radiators of the tubular type,” Publications in Engineering, vol. 2, Berkeley: University of California, 1930, pp. 443–461.
   Google Scholar
• P. Wu and W. A. Little, “Measurement of the heat transfer characteristics of gas flow in fine channel heat exchangers used for microminiature refrigerators,” Cryogenics, vol. 24, no. 8, pp. 415–420, 1984.
   Web of Science ®Google Scholar
• D. Yu, R. Warrington, R. Barron, and T. Ameel, “An experimental and theoretical investigation of fluid flow and heat transfer in microtubes,” ASME/JSME Therm. Eng. Conf., 19–24 March, Lahaina, Hawaii, USA, vol. 1, no. 52, pp. 523–530, 1995.
   Google Scholar
• T. M. Adams, M. F. Dowling, S. I. Abdel-Khalik, and S. M. Jeter, “Applicability of traditional turbulent single-phase forced convection correlations to non-circular microchannels,” Int. J. Heat Mass Transfer, vol. 42, no. 23, pp. 4411–4415, 1999.
   Web of Science ®Google Scholar
• E. N. Sieder and G. E. Tate, “Heat transfer and pressure drop of liquids in tubes,” Ind. Eng. Chem., vol. 28, no. 12, pp. 1429–1435, 1936. doi:10.1021/ie50324a027.
   Google Scholar
• F. T. Kanizawa, C. B. Tibiriçá, and G. Ribatski, “Heat transfer during convective boiling inside microchannels,” Int. J. Heat Mass Transfer, vol. 93, pp. 566–583, 2016.
   Web of Science ®Google Scholar
• G. M. Lazarek and S. H. Black, “Evaporative heat transfer, pressure drop and critical heat flux in a small vertical tube with R-113,” Int. J. Heat Mass Transfer, vol. 25, no. 7, pp. 945–960, 1982.
   Web of Science ®Google Scholar
• L. Sun and K. Mishima, “An evaluation of prediction methods for saturated flow boiling heat transfer in mini-channels,” Int. J. Heat Mass Transfer, vol. 52, no. 23, pp. 5323–5329, 2009.
   Web of Science ®Google Scholar
• T. N. Tran, M. W. Wambsganss, and D. M. France, “Small circular-and rectangular-channel boiling with two refrigerants,” Int. J. Multiphase Flow, vol. 22, no. 3, pp. 485–498, 1996.
   Web of Science ®Google Scholar
• W. Li and Z. Wu, “A general correlation for evaporative heat transfer in micro/mini-channels,” Int. J. Heat Mass Transfer, vol. 53, no. 9, pp. 1778–1787, 2010.
   Web of Science ®Google Scholar
• J. R. Thome, V. Dupont, and A. M. Jacobi, “Heat transfer model for evaporation in microchannels. Part I: presentation of the model,” Int. J. Heat Mass Transfer, vol. 47, no. 14, pp. 3375–3385, 2004.
   Web of Science ®Google Scholar
• S. M. Kim and I. Mudawar, “Universal approach to predicting saturated flow boiling heat transfer in mini/micro-channels–Part II. Two-phase heat transfer coefficient,” Int. J. Heat Mass Transfer, vol. 64, pp. 1239–1256, 2013.
   Web of Science ®Google Scholar
• S. G. Kandlikar and P. Balasubramanian, “An extension of the flow boiling correlation to transition, laminar, and deep laminar flows in mini-channels and micro-channels,” Heat Transfer Eng., vol. 25, no. 3, pp. 86–93, 2004.
   Web of Science ®Google Scholar