Local Heat Transfer Characteristic Coincidence in Helically Coiled Tubes Under Different Heating Conditions

References

• S. Jaisankar, T. Radhakrishnan, and K. Sheeba, “Experimental studies on heat transfer and friction factor characteristics of thermosyphon solar water heater system fitted with spacer at the trailing edge of twisted tapes,” Appl. Therm. Eng., vol. 29, no. 5–6, pp. 1224–1231, 2009. DOI: 10.1016/j.applthermaleng.2008.06.009.
   Web of Science ®Google Scholar
• J. Jayakumar, S. Mahajani, J. Mandal, P. Vijayan, and R. Bhoi, “Experimental and CFD estimation of heat transfer in helically coiled heat exchangers,” Chem. Eng. Res. Des., vol. 86, no. 3, pp. 221–232, 2008. DOI: 10.1016/j.cherd.2007.10.021.
   Google Scholar
• P. Congedo, G. Colangelo, and G. Starace, “CFD simulations of horizontal ground heat exchangers: A comparison among different configurations,” Appl. Therm. Eng., vol. 33, pp. 24–32, 2012. DOI: 10.1016/j.applthermaleng.2011.09.005.
   Web of Science ®Google Scholar
• P. Naphon, “Study on the heat transfer and flow characteristics in a spiral-coil tube,” Int. Commun. Heat Mass Transf., vol. 38, no. 1, pp. 69–74, 2011. DOI: 10.1016/j.icheatmasstransfer.2010.10.007.
   Web of Science ®Google Scholar
• W. Dean, and J. Hurst, “Note on the motion of fluid in a curved pipe,” Mathematika, vol. 6, no. 1, pp. 77–85, 1959. DOI: 10.1112/S0025579300001947.
   Google Scholar
• W. Dean, “LXXII: the stream-line motion of fluid in a curved pipe (Second paper),” Lond. Edinb. Dublin Philos. Mag. J. Sci., vol. 5, no. 30, pp. 673–695, 1928. DOI: 10.1080/14786440408564513.
   Google Scholar
• M. Jensen and A. Bergles, “Critical heat flux in helical coils with a circumferential heat flux tilt toward the outside surface,” Int. J. Heat Mass Transf., vol. 25, no. 9, pp. 1383–1395, 1982. DOI: 10.1016/0017-9310(82)90132-6.
   Web of Science ®Google Scholar
• R. Xin and M. Ebadian, “The effects of Prandtl numbers on local and average convective heat transfer characteristics in helical pipes,” J. Heat. Transf., vol. 119, no. 3, pp. 467–473, 1997. DOI: 10.1115/1.2824120.
   Web of Science ®Google Scholar
• W. I. Louw and J. P. Meyer, “Heat transfer during annular tube contact in a helically coiled tube-in-tube heat exchanger,” Heat Transf. Eng., vol. 26, no. 6, pp. 16–21, 2005. DOI: 10.1080/01457630590950835.
   Web of Science ®Google Scholar
• J. J et al., “CFD analysis of single-phase flows inside helically coiled tubes,” Comput. Chem. Eng., vol. 34, no. 4, pp. 430–446, 2010.
   Web of Science ®Google Scholar
• Y. Ferng, W. Lin, and C. Chieng, “Numerically investigated effects of different Dean number and pitch size on flow and heat transfer characteristics in a helically coil-tube heat exchanger,” Appl. Therm. Eng., vol. 36, pp. 378–385, 2012. DOI: 10.1016/j.applthermaleng.2011.10.052.
   Web of Science ®Google Scholar
• H. Aria, M. A. Akhavan-Behabadi, and F. M. Shemirani, “Experimental investigation on flow boiling heat transfer and pressure drop of HFC-134a inside a vertical helically coiled tube,” Heat Transf. Eng., vol. 33, no. 2, pp. 79–87, 2012. DOI: 10.1080/01457632.2011.589310.
   Web of Science ®Google Scholar
• X. Niu, S. Luo, L. Fan, and L. Zhao, “Numerical simulation on the flow and heat transfer characteristics in the one-side heating helically coiled tubes,” Appl. Therm. Eng., vol. 106, pp. 579–587, 2016. DOI: 10.1016/j.applthermaleng.2016.05.167.
   Web of Science ®Google Scholar
• J. Wen, H. Huang, Y. Fu, G. Xu, and K. Zhu, “Heat transfer performance of aviation kerosene RP-3 flowing in a vertical helical tube at supercritical pressure,” Appl. Therm. Eng., vol. 121, pp. 853–862, 2017. DOI: 10.1016/j.applthermaleng.2017.04.055.
   Web of Science ®Google Scholar
• Y. Fu, H. Huang, J. Wen, G. Xu, and W. Zhao, “Experimental investigation on convective heat transfer of supercritical RP-3 in vertical miniature tubes with various diameters,” Int. J. Heat Mass Transf., vol. 112, pp. 814–824, 2017. DOI: 10.1016/j.ijheatmasstransfer.2017.05.008.
   Web of Science ®Google Scholar
• Y. Fu, G. Xu, J. Wen, and H. Huang, “Thermal oxidation coking of aviation kerosene RP-3 at supercritical pressure in helical tubes,” Appl. Therm. Eng., vol. 128, pp. 1186–1195, 2018. DOI: 10.1016/j.applthermaleng.2017.09.101.
   Web of Science ®Google Scholar
• F. A et al., “Thermal performance modeling of turbulent flow in multi tube in tube helically coiled heat exchangers,” Int. J. Mech. Sci., vol. 135, pp. 621–638, 2018.
   Web of Science ®Google Scholar
• S. Berger, L. Talbot, and L. Yao, “Flow in curved pipes,” Annu. Rev. Fluid. Mech., vol. 15, no. 1, pp. 461–512, 1983. DOI: 10.1146/annurev.fl.15.010183.002333.
   Google Scholar
• S. Kakaç, R. K. Shah, and W. Aung, Handbook of single-phase convective heat transfer, John Wiley and Sons Inc; New York, NY (USA), 1987. ISBN 0-471-81702-3.
   Google Scholar
• P. Naphon and S. Wongwises, “A review of flow and heat transfer characteristics in curved tubes,” Renew. Sustain. Energy Rev., vol. 10, no. 5, pp. 463–490, 2006. DOI: 10.1016/j.rser.2004.09.014.
   Web of Science ®Google Scholar
• A. Fsadni, J. Whitty, and M. A. Stables, “A brief review on frictional pressure drop reduction studies for laminar and turbulent flow in helically coiled tubes,” Appl. Therm. Eng., vol. 109, pp. 334–343, 2016. DOI: 10.1016/j.applthermaleng.2016.08.068.
   Web of Science ®Google Scholar
• M. S. El-Genk and T. M. Schriener, “A review and correlations for convection heat transfer and pressure losses in toroidal and helically coiled tubes,” Heat Transf. Eng., vol. 38, no. 5, pp. 447–474, 2017. DOI: 10.1080/01457632.2016.1194693.
   Web of Science ®Google Scholar
• K. Misurati, Y. Quan, W. Gong, G. Xu, and Y. Yan, “Contrastive study of flow and heat transfer characteristics in a helically coiled tube under uniform heating and one-side heating,” Appl. Therm. Eng., vol. 114, pp. 77–84, 2017. DOI: 10.1016/j.applthermaleng.2016.11.168.
   Web of Science ®Google Scholar
• G. Rogers and Y. Mayhew, Thermodynamic and Transport Properties of Fluids. Oxford: Blackwell, 1981.
   Google Scholar
• T. Shih, W. W. Liou, A. Shabbir, Z. Yang, and J. Zhu, “A new k−ϵ eddy viscosity model for high reynolds number turbulent flows,” Comput. Fluids, vol. 24, no. 3, pp. 227–238, 1995. DOI: 10.1016/0045-7930(94)00032-T.
   Web of Science ®Google Scholar
• H. Ito, “Friction factors for turbulent flow in curved pipes,” J. Basic Eng, vol. 81, no. 2, pp. 123–134, 1959. DOI: 10.1115/1.4008390.
   Google Scholar